Siemens V90 servo drive wiring, set up, auto tune and configuration using V Assist. Please see helpful manuals from seimens below. TIA portal setup: cache.industry.siemens.com/dl... V90 Manula: cache.industry.siemens.com/dl...
Пікірлер: 11
@EdgarEstoesta3 ай бұрын
Thank you boss IGS for your videos this were help us beginners big and to encourage to do more and think big, thank you very much Boss....
@framos9991 Жыл бұрын
Thanks!
@tehseenarshad8602 Жыл бұрын
thanks boss
@nomandanish441 Жыл бұрын
Great
@augustinmarker3444 Жыл бұрын
i noticed you never used the setpoint cable i am new to this, is profinet cable sufficient? or do we have to connect seperate pto outputs as well
@ahmedzm8029 Жыл бұрын
I have one question, when we do an autotune, should we do that with or without load?
@TomSmith-eq1vr Жыл бұрын
Your videos have been very informativ and a massive help. I am looking at building an automated machine using mainly siemens parts. Will need a siemens PLC to drive a 1.2kw Servo, a 2.2kw sew Euro drive 3phase geared motor and VFD and a HMI to control the whole show alone with some push buttons. Could you steer me in the right direction to choosing the correct siemens PLC.
@IGSElectronics Жыл бұрын
Hi Tom. It all depends on complexity of the project. If the project is just turn things on, have some basic logic, with basic functions, no complex data collection, analysis , calculations and so on, a basic Logo would do. Logo can do a lot for such a small an cheep controller.
@thomassaook7787 Жыл бұрын
Great work, how can I be a part of your team?
@vc-go48 Жыл бұрын
Why can't I connect to ethernet at vstant connection?