Upon simulation, I am facing the error "Port Refinement, process hf3d error: Too few conductors were found on port port1. There should be one conductor for each terminal with one additional reference conductor. Unintentional contact between conductors may cause this error.". How can I resolve this error ? I have followed the same steps as shown in the video
@AnsysLearning Жыл бұрын
Thanks for watching! Please post your query on the Ansys Learning Forum for a detailed answer from the wider Ansys Community: ansys.com/forum.
@zacharyprime110 ай бұрын
This is a bad way to answer this. Following the exact instructions of the video causes this error.@@AnsysLearning
@shayankhorassany844710 ай бұрын
I had the same issue, but after I applied the same Solution type (00:34) it was fine. I had to choose the Terminal modal port for the assigning excitation
@husseinhamieh63573 жыл бұрын
How to add thickness to the copper trace and the ground?
@AnsysLearning3 жыл бұрын
Thanks for watching! Please visit our Ansys Learning Forum for an answer to your question: www.ansys.com/forum.
@rjrodrig3 жыл бұрын
How did that plane get created?
@sej4437 Жыл бұрын
Why don't you set a radiation boundary?
@AnsysLearning Жыл бұрын
Thanks for watching! Please post your query on the Ansys Learning Forum for a detailed answer from the wider Ansys Community: ansys.com/forum.
@WilmottKay-c3mАй бұрын
Caleigh Cliff
@zoto47402 ай бұрын
some sections are too fast for a tutorial + obsolete + bad design (strip and plane should have some thickness)
@AnsysLearning2 ай бұрын
Thanks for watching & providing feedback! Visit Ansys Innovation Courses for free courses, including videos, handouts, simulation examples with starting files, homework problems, and quizzes here: ansys.com/courses.