SINGER 201-2 sewing machine removing parts for cleaning, and restoration.

Today's job is prepping a SINGER 201-2 sewing machine for cleaning, and a minor restoration I will only be checking and cleaning main driveline parts. The end of the video will show the machine stripped down before beginning the process. Part #1

[@kedahaakedahaa2733]

اود متبابعتك. شرح جميل على الاشاره مافهم كلامك❤

[@debbiestuttgen1825]

Wow, you can sure tell this isn't your first rodeo. Great video. Thank you.

[@rhondamercado7527]

I just found this machine last weekend and so far this has been the most informative and specific video yet. Thanks for sharing. I did purchase it at a pretty pristine state so hopefully I won’t have to remove too many parts to get it cleaned, oiled and lubricated. I was kind of thrown off when you mentioned to put oil on the gears along with the grease. I’ve always understood that oil never goes on gears.

[@stevel9353]

Very good video. The only thing I noticed is the fact that you suggested a small amount of grease on the gears. The manual only calls for oil. Thanks for posting this!

[@justincranford7249]

Do you happen to have a slide plate for one of these machines that would be for sale

[@DeebeeNonya]

Great video! It will really help when I pick up my 201-2 later today. I did want to ask what type of car polish do you use? Thanks!

[@alcas7864]

I was looking at these machines when this video came out. I found one locally for $100 in original cabinet. Sadly i have no room and too many machines 🤷🏻‍♂️

[@rscruiser3533]

I just came across your site --- I have a 201-2 -- from a previous house I lived in -- have not used yet --- would like to go through it -- clean / lube -- If I am going to go this far into it --- is there a few more steps to --- Get It All --- then put it back together? ---- And also --- is there a parts break down -- whether it is one large drawing -- or individual areas showing the break down. of each --- You had a GOOD EXAMPLE of this --- a Washer -- missing under the Thumb Screw for the presser foot you knew --- but I wouldn't have--- Where to go for a break down --- I couldn't tell you if a part is missing or not ---- Really Enjoyed Your Video --- Subscribed to Learn More ------ Thank You ----- Rodney

[@barbaraphillips3499]

I have a 201 I took off the face plate,back plate, throat plate, bobbin winder thread guide , thumb screw for presser foot . I put everything back and now have a little washer that I don't know what it goes to

[@Mesagsp]

A very good video on disassembly on these machines. Great job and camera work. Ive probably asked this before, but what camera and tripod/mount are you using?

[@BlacksPorsche986]

Using a Sony ZV-1 camera in 4k and publishing in 1080p this gives me a bit of headroom if I want to zoom in.

[@connieworcester55]

I just bought a 201-2 ,,, and the plastic screw head is broken off, on the top of the motor where the brushes go, can I buy a replacement?... AND, getting the broken one out might be a challenge. I wonder if I could make a "slot" in it with a soldering iron? or ? something? without causing any damage.? then try and get a screwdriver in the "make shift slot" and maybe turn it out? any suggestions would be greatly appreciated.. thank you.

[@isamarcho7484]

How to remove thread that stack in the bovine