Skidoo skandic 440 LT rebuild Part 2: motor is out steering shaft is in

[@PJ-si2po]

I own a 2007 Skandic 440F that I bought new for USA and it always been stored inside a garage it is still in showroom condition The job you are doing is amazing and requires a ton of patience

[@sebastiengauthier2785]

Hi there I have a 440f skandic and can't figure out how to take the clutch out it's free from the shaft but can't get it out do I need to take out the plastic air vent ??? How to you do it

[@RYANHODGE100]

I think you have to unbolt a bracket holding the belly pan, then you can bend the belly pan out mastic away from the clutch and yank it out past the crank.

[@magicmilkbotlle7517]

Either the vent or there is two 10mm bolt on the bolting the side of the belly pan to the frame and you can pull it back quite a ways. For the primary that the only way I could sneak it out