SOLIDWORKS World: Model Mania 2012

[@matrix31003]

Training with these videos has been very instructive. I make the models myself and then watch how they are designed here and always pick up a lot of tips every time I go through them. I've done this with almost every model in the model mania series.

[@janveit2226]

I really likes these videos, it is not overwhelming (to much info at time). I use SolidWorks for years, but I always learn something useful.

[@solidworks]

Hi Jan Veit! We're please to hear that you enjoy our videos content! 😃

[@lockpickingmen]

I love these videos. Thanks for uploading here

[@cybermascot]

i love these videos too, there is so much to learn from these.

[@davareyalester2829]

You all need to post mass solutions because we have no way of knowing if we are correct or not!

[@ondermetu]

Having obtained FOS value of 2.43761 I could attain this year's model more accurately than the other year's models up to 2012

[@filmecho6474]

Weight ?

[@iulianmoga9410]

Good Job ! Thanks for tutorial !

[@chrisblight6069]

Great videos, all of them from this source. Also very nicely narrated. I have to say though that my FOS always seems to be very slightly out. Displacement figures come up the same but the FOS just a tiny bit out. For instance on this part my FOS was 2.41165 instead of 2.43883. I'm not sure what difference this makes or why it does that.

[@whosthisguythinkheis]

they're determined using numerical methods so there is an inherent variance is the results. the percentage difference right there is inside 5% so its close enough.

[@ShayanAsim]

And my FOS came out to be 2.42799

[@ondermetu]

Mine is another answer 2.41062

[@ondermetu]

Not only precision but also accuracy is incorrect as far as I can see

[@mohammedal-sayed159]

this variance depends on your mesh settings and the way you tweaked it so as far as your answers is with in the 5% range you are good to go

[@aurorabalderas7953]

I did all the steps exactly like you and the safety factor is not the same. Why?? This happens in all videos

[@solidworks]

Hi Aurora! Could you please provide your email address? So we can look into the specific behavior you are experiencing and help you identify the root of the problem and provide a solution.

[@sagarroy3231]

why cant i snap my sketch at the end of the part? for the cut extrude.

[@ajaynarayanan2326]

That simulation was cringy 😂