SOLIDWORKS World: Model Mania 2010

[@sawyerswaim401]

Amazing tutorial. Might be the most I've learned in a single video. Some very out-of-the-box tools used that I hadn't seen/used yet

[@SuperFabiotv]

The tips , which you gave in this video, are all very accurate and usefull for one like me that wants to learn more about this awesome programm :D

[@mohammedaitalisaid4328]

what I do every time is to take the drawings, do the 3D modeling myself, then see if my method is the right one. in general, my method is practically similar to that of the answer key.

[@ondermetu]

Good to see the mass properties at @9:40 :)

[@ssund3966]

A question I have... After having completed the model, what is judged to be the correct weight in context of mass properties? I get 317.63g

[@israelcontreras9788]

318.68 g here

[@EduardSidorov-i3f]

Спасибо большое. Отличный урок. 👍

[@Vanguyen09]

Hahaha. Thank you. Watching you modeling this part. I learn a lot of commands that I never know. Thank you very much.

[@raulirimias4810]

Fantastic lesson. Thank you for sharing.

[@Nok1dp]

As I understand the low level of safety in a greater degree caused by improper ratio of radii that make a thickness of 8 mm element is less than 8 mm. Or curvature of the element affects more?

[@ondermetu]

FOS value showed up around 2.52 for my simulationXpress

[@triathlon.75]

Awesome tutorial.

[@mpam002]

2.38 i was trying ti sketch the offset and cut extrude it for about 20 minutes , he did it in 1 minute lol

[@chetnaprajapati9483]

how to sync two circle example:- one circle dia75mm and secound circle dia1000mm dia1000mm (1000mm-100mm=900mm) so change dia 75mm change (75mm+100=175mm) mins i one circle dia minuse so secound dia pluse is value how create बहुत बढ़िया पर मुझे ऐसा काम कुछ इस तरीके से करना हो तो कैसे करे कृपया बताये जैसे के एक circle 75mm dia का हे और दूसरा circle 1000mm dia का हे अगर में इन दोनों में से किसी की भी साइज़ बदलता हु तो वो एक दुसरे में pluse minus खुद्ब्खुद हो जाये जैसे के अगर में 75 mm dia में 25 mm जोड़ता हु तो वो dia 100mm हो गया पर जो दूसरा dia जो 1000 mm का हे वो 975mm खुद्ब्खुद हो जाये बस ऐसे कोई भी एक dia अगर pluse होता हे तो दूसरा dia खुद्ब्खुद minuse हो जाना चाहिए और कोई भी एक dia minuse होता हे तो दूसरा dia खुद्ब्खुद pluse हो जाना चाहिए हा पर जितना हम pluse या minuse करते हे उतना ही value एक दुसरे dia में pluse minuse होना चाहिए कृपया करके ये बताये ये कैसे हो सकता हे solidwork में ?

[@ZENZELEAN]

someone send it to me via email pls i need the file