SP Concepts 2 into 1 Lane Splitter Exhaust Install on Harley Davidson Street Bob 114

[@davenicolecarscadden9045]

I just put on the SPC Big Bore 4.5 on my 2021 Fat Bob 114. The sound is sick, the increase in power and torque is unbelievable. These guys are known for making great products and I couldn't be happier. Everything about it is top notch. Customer service was fantastic and these guys deserve to be supported. You want a top notch exhaust system from guys who don't disappear after they have your money, look no farther because these are the guys. Much thanks to Mark and Greg and I wish you guys the very best. Keep doing what you're doing and you can't go wrong.

[@WeRide2]

Agreed across the board.

[@cpane420]

Alot of folks are running this setup on stock Tune with zero issues , I'm pulling the trigger next week on a set , was going with Sawicki but the price is right on the Sp Concepts

[@WeRide2]

This is true, it may not be completely necessary unless there's a stage 2 or better in the near future. Agreed, I was looking at Sawicki myself but the price is right on these SP Concepts exhaust systems. Very happy with the quality and sound.

[@EpicKook]

I cannot stand the placement of the springs on the Sawickis.

[@nhzxboi]

You can just leave the heat shields on. They don't really get in the way. That way you can take the 20lb pile of OEM stuff and pile it into a corner somewhere for safe keeping. I put the same thing on my FXLRS yesterday. Less than a 1 hour job. But I did use new exhaust gaskets and folks should know that those "clips should be embedded in the recess of the flange...not hanging loose. Loosely fitting the bracket on the muffler is the only way I could get it installed. Tighten later. I actually had to crush those j-nut clips so those short bolts could go in. Not a big deal if you're mechanically inclined.

[@johnnydangerously7186]

Beautiful craftsmanship. Love the brushed satin finish. Going to look awesome once it goes through a few heat cycles.

[@WeRide2]

Yea its really beautiful! Agreed with the heat cycles, can't wait.

[@TygurTygurr]

Damnn, looks good. I’ll never look at stock pipes the same again 😎

[@nikom1449]

Great video. keep up the good work. keep them coming!!

[@WeRide2]

Thank you!

[@silkycherry]

Sounds and looks great! can't wait to see more. 👍

[@WeRide2]

Thank you! More coming!!

[@lio1999]

Very nice looking and sound exhaust. Is it possible to measure the exhaust decibel? I need an exhaust which comply with traffic regulations.

[@WeRide2]

I don't have a decibel meter but I'll try using an app on my phone.

[@lio1999]

@@WeRide2 thanks alot

[@WeRide2]

you're welcome...video drops today for you...hope it helps

[@lio1999]

@@WeRide2 Thanks bro for the great video

[@WeRide2]

Hope it helps, would love to hear which one you decided to go with.

[@aryneto11]

Really nice!! Bike looks great. 🔥🔥

[@WeRide2]

Thank you my brother!

[@TheMotoJawn]

Awesome I'm just about sold on this one. How's it running with no tune?

[@WeRide2]

It's beautiful, only got a chance to take it around the block so far. Been raining all week down here. Next episode will be the tune and the comparison between the two...

[@logmaster56]

How did you remove and reapply the bolt on the front header that’s closest to the front wheel?

[@WeRide2]

I used a swivel attachment on the ratchet

[@Pigwatch415]

Looks and sounds great! What air filter are you running and are you running a tune atm?

[@WeRide2]

Thank you! That's the HD stock ventilator with Fuel Moto's BMF oversized air filter. I will be putting a tune it as well via the Dynojet Power Vision (next episode).

[@Pigwatch415]

@@WeRide2 ok. Wanted to get a larger air filter to go with my slip ons without having to tune it and void my warranty

[@WeRide2]

Sounds good, I'm looking into getting it put on a dyno so i can share some numbers with you guys.

[@marvelharris9540]

do these shorty style pipes produce high torque and hp numbers?

[@WeRide2]

I would say it depends on what you pair them with as far as cam and intake. But the M8 favors longer pipes if I'm not mistaken.

[@locoocho2415]

Sounds great 👍

[@WeRide2]

Thanks!!!

[@illduitmyself]

You look like eric koston the skater but the straight version

[@WeRide2]

LMAO!! I've been called worse

[@barry7874]

Looks good

[@WeRide2]

Thank you!

[@FXDRonin]

Why did you leave the stock mounting bracket on?

[@WeRide2]

Because by the time I realized I just wanted to finish the video...LOL but it's off

[@FXDRonin]

@@WeRide2 haha yeh fair enough mate

[@Murderbation]

Anyone got an opinion on the spc vs tbr?