I knew the rs had potential. I think it can hit 10s with a nx2 and built short block. All we see online is low 12s and very few 11s.
@randyms38302 жыл бұрын
Nishan? There's a name I haven't heard in a while.
@joetyszk332 жыл бұрын
Should sell a mahle piston/rod & turbo kit for the 2.3 mustang, especially for those 15-19’s that don’t have the stronger connecting rods, so this swap can be done on the ecoboost as well
@kindica092 жыл бұрын
I miss Nishan's videos!
@BigBadBillyGATEZ Жыл бұрын
I bought their Pop and drop kit for my Focus ST back in 2014 and it held 422whp like a champ till I sold it. My current RS makes 440 whp with NX2 and E30 over a yr no issues on stock block stock internals. If this pop and drop kit can handle 500 to 550whp on the stock open deck with upgraded fuel to run e50 I'll do it but I don't trust the open deck hmmm 🤔 but as long as the tune is flawless and no knock to damage the cylinder walls I suspect it can hold the power...I'm just hesitant to pay to transfer everything to a closed deck. Shops change too much...pop and drop labor is wayyyyyyy cheaper.
@1stWorldProblemsSolved Жыл бұрын
Some of the EU guys run 2.3 block with cylinder support at 500-550whp
@moonrider99 Жыл бұрын
With a built engine, how much more hp/tq can you get out of stock turbo on 93 octane, WITHOUT compromising turbo life too much.
@SrgBlackburn2 жыл бұрын
Wait the RS has a rubber overflow hose!? Damn ST overflow hose always breaking.
@Boegh91 Жыл бұрын
whats done to the car over the pop and drop cause thats fast as hell for stock turbo and if i can get even close to that on my stock engine "shut up and take my money"
@fine17st Жыл бұрын
Need more videos lol
@Dominiks_ Жыл бұрын
is it not needed to balance the crankshaft with new rods and pistons ?
@velocitywot9573 Жыл бұрын
Why are these taking so long to crack 10s ? I would’ve thought this was the platform to beat. The fwd type Rs are into the 9s. One ran a 9.6 at 141mph
@Thatjediguy172 жыл бұрын
How long did it take to install the pop and drop?
@speedperformance2 жыл бұрын
this was done overnight at the shop. Probably a good 8-10hrs
@Thatjediguy172 жыл бұрын
@@speedperformance Good shit. Didn't realize you could drop pistons without pulling the motor. Looking forward to more content.