Speeduino 36 - 1 trigger wheel test

[@FilterYT]

I'm glad to be aware of a Hall effect sensor that has simple 3 wire connection and digital output. Thanks for sharing.

[@benroweben]

Great video mate thanks for taking the time

[@lyndonevans1251]

Hi Ben Thanks, an important point about this sensor is that it must be mounted with the connector plug at 90° to the trigger wheel (not in line with it)! Or to put it another way the connector plug must be in line with the centre line of the crank.

[@lyndonevans1251]

I don't use 0.4.x boards but from the manual, looks like pin 25 is signal data for crank sensor, pin 9, 10 or 12 (gnd) for the gnd connector and you need a +12volts for the other wire.

[@SidneyCritic]

Do you have another wheel with less tooth mass. I was wondering how small you can go before it has trouble working, ie will it work with 3mm teeth on a 3mm thick disk.

[@enriquemartinez1596]

Which brand is the escope???

[@Jorge_11ernandez]

Could you tell me to which pins each cable is connected in the speeduino 40 idc socket? Thanks

[@steveguest8028]

What oscilloscope is that ?

[@GCMasterD]

Jumper config on speeduino? I dont have any signal

[@johnsmith-cu2pg]

Try to run that trigger over 4000rpm. I get sinc loose after that point. I use more tick trigger now. With 306 s16 vr sensor

[@lyndonevans1251]

Strange. This runs on a 60-2 on a BMW. What diameter/tooth count are you using.

[@johnsmith-cu2pg]

The same trigger as you but 130mm it was made for siera rs 36-1

[@lyndonevans1251]

Hi No this is the only wheel i have at the moment. Sorry