Sprinter Camshaft Positioning Sensor Repair, Replacement Re-edited

It might not be your camshaft Positioning Sensor
Here's some tools for the job
These are affiliate links. I get paid when you use them. They help buy the coffee that goes into making these videos!
Scotch Locks
amzn.to/2v5eo3f
Scotch lock pliers
amzn.to/2upPNGf

[@eby6114]

Sorry, re-edit of my original video to make it a little bit clearer. Thanks for your patience!

[@denysp5695]

Thank you so much for this video! What error codes or signs did you have to replace the sensor?

[@eby6114]

It's been a long time and I don't remember the codes but the engine would just stall and I would reposition the wiring harness and it would start back again so I knew it had to be in there

[@denysp5695]

@@eby6114 do you have a diagram by any chance for camshaft sensor? Because i tested 1,2,3 injectors but can’t find a electrical diagram for camshaft

[@eedumi1gmail]

Thank you for the video,, did you change the camshaft sensor also.?

[@eby6114]

Replaced the camshaft sensor nor the crank.

[@antuantube3069]

¿Cuáles son los síntomas de este sensor de posición? Cuando falla

[@frontlinemedia4270]

So where did you end up making the spliçe?

[@eby6114]

It was the cam sensor line

[@frontlinemedia4270]

@@eby6114 I have 16 as a resistance for the cam and mass air flow sensor wires (yel-br)

[@eby6114]

@@frontlinemedia4270 unfortunately it's a problem like this. Diesel engine vibrates. Wires in suspectable location. Wire breaks. We test the wire seems good because it's in a touching position but while driving wires become disconnected reconnected. I temporarily solved my no run issue blllt relocating the harness which put pressure on the broken wire reconnecting through tension...sort of like rotating a battery terminal post to get a car started until you get somewhere you can fix it. I have a video discussing the problem, the relocating with zip ties etc. It's actually a common problem and they'd normally "just" replace the wiring harness

[@frontlinemedia4270]

@@eby6114 I pulled on everything and really couldn't get it to change. I had around 16 ohms on that wire. Vehicle drains the battery if sits. Also another mechanic said that wire was the power supply, but it can't be. I don’t have a wire diagram for it yet. I will have to find your other video

[@eby6114]

@@frontlinemedia4270 ok so there's one more video you might check out. Not sure it's related but the main power fuse. I can't remember if it's going to the starter or battery. Anyway located under the truck is the main fuse that seems to go bad with corrosion. I replaced mine with an aftermarket fuse.

[@eedumi1gmail]

What year is that sprinter.?

[@eby6114]

2007

[@eedumi1gmail]

Mine is 2012 but the sensor is on the same place as your thanks God