Starter Replacement 2016-2020 GMC Sierra. Silverado

[@trentporter4234]

Great video. This solved my intermittent no start problem

[@eddie.ls.c103]

Did it sound like the battery was dead?

[@trentporter4234]

Similar sound but when you turn the key one click and then complete dead dashboard

[@c6corvettels336]

Same thing happen to my 2016 gmc sierra Denali with 110,00 miles. Turn the key one click and dead dashboard I though it was the battery at first but ended up been the starter..

[@wayneroberts7852]

Very helpful, i forgot where that black shield went! Haha thanks man!

[@Autoenginecheck]

Thanks FOR comment sir

[@averygentry35]

I have a 2014 Silverado with 4.3 and I can’t find one single video changing the starter on a V6 4.3. Is the 4.3 pretty much the same as this? Thanks for video was good !

[@Autoenginecheck]

yes sir same

[@punt4madre]

No the 4.3 v6 is a much more difficult job that's why there are not videos of that job. Especially if it's a 4wd gotta remove front diff mounting bolts to get starter out

[@paulkadamus2944]

Good video I like how you showed every nut and bolt to make sure they go back in

[@Autoenginecheck]

Thanks FOR comment sir

[@Manuel-nk7go]

What year is this truck?, is the same for 2020?.

[@rickydoherty1147]

this is great. thank you. can i do this in my driveway or do i need a lift? Also, did you remove the wheel to get at it or the liner inside the wheel well? thank you for posting this

[@Autoenginecheck]

No need for a lift. Take the 13mm box.10mm. 8MM ranges a little higher with the car's own jack Battery - Take it off

[@rickydoherty1147]

@@Autoenginecheck thank you so much. cheers

[@rashedomar9349]

How much is the starter ?

[@2strokeFORever]

So you drop the starter with the signal wire connected? I assume that makes it easier to get that stupid clip

[@Manuel-nk7go]

When I start the truck the battery goes down to 10.53 v and then goes to 13v, do you think is the starter the problem?.

[@Autoenginecheck]

The starter motor is weak

[@Manuel-nk7go]

@@Autoenginecheck I gonna replace the starter, thank you.

[@alvarez6335]

Amigos lectores ustedes me pueden ayudar, tengo una gmc sierra 2020 con 25000 millas motor 2.7 lt turbo y se me daña a cada cuatro meses el motor de arranque, el dealer me dijo que posiblemente la caja principal de fusibles estaba dando problemas , se le cambió y mejoró algo , pero justamente ayer se me dañó nuevamente el motor de arranque y ya son tres veces que se reemplaza y quizás con un consejo de ustedes puedo yo mejorar esta situación.

[@Autoenginecheck]

Assalamualaikum verifique el relé de arranque y el empuje de encendido (que arranca el motor) sincronización del arranque, muchas veces el arranque se enciende con el motor en marcha, hemos tenido ese problema. Así que échale un vistazo.

[@joediduch5457]

Is the crankshaft position sensor rite their also

[@Autoenginecheck]

yes Sir

[@joediduch5457]

@@Autoenginecheck thank you! I figured Ive been looking to replace it but theres no video anywhere on youtube

[@crittergetter9071]

What engine size was this?

[@Autoenginecheck]

6.2

[@Jonnygriz]

Easier to take the fender liner out and go from there

[@Autoenginecheck]

Yes sir

[@amalmfqod]

Where is your location ..?

[@Autoenginecheck]

Abu Dhabi M14

[@amalmfqod]

@@Autoenginecheck i have the same issue .. tomorrow the garage is open ?

[@Autoenginecheck]

@@amalmfqod 12 July open

[@Adrian-jo3bk]

The Squeaking noise is still there

[@Autoenginecheck]

Fly wheel check status bolt properly check And check front all belt

[@nickoneal7166]

L4

[@danieljohnston1914]

Comments would be more a help, than this guy singing! Blah.

[@Autoenginecheck]

Thanks for comment sir