Star Trac: Spinner® Morse Taper Bottom Bracket Replacement

[@ggregory2031]

This is so helpful-the most informative and clear step-by-Step I’ve ever seen.

[@thenomadcoder]

i have a bh sb1.0 im having trouble with it, and i needed to fix this bottom bracket and replace it, this video helps a lot, thanks!

[@morgangronqvist1347]

Hi, thanks for great instructions video’s. I wonder, where do I see the serial number on my Star Trac Spinning Blade?

[@daniellelech]

Do you have any tips or suggestions for a driver side bearing that won't come out?

[@abm7104]

what torque are you using on the bolts?

[@GNX157]

Anyone doing this, I suggest coating the shaft and bearing contact surfaces with a thin layer of hydrophobic grease. It will make later removal much easier because sweat and water will tend to cause this area to have corrosion.

[@kenlor71]

Any thoughts on very loud vibration/noise at high rpms ?

[@carloskaya5765]

What is the size of the bearings?

[@iheartsamus5605]

What size wrench did you use to remove the Jam Nut? At timestamp 2:20

[@aminaasha197]

Thank you

[@ronanorourke4848]

Cheers

[@craighough5886]

It’s a dead blow hammer, not a runner mallet.