Which gives best result static pile load test or dynamic pile load test
@kanarajan5 жыл бұрын
static load test is the best for measure the actual settlement. But the dynamic one is easy, low cost and quick one. skin friction and end bearing values can be evaluated separately through the PDA. Also PDA used for comment abut integrity of pile. static load test is only for settlement measurement while loading. So, it is based on your requirement dear friend.
@user-ds4kd4eh9q5 жыл бұрын
@@kanarajan thanks
@AchmadKomarudin-qq4kz7 ай бұрын
Ko dail nya taro di plat kalau pelat nya melengkung , taro di tiang atuh bosku
@TEMELTASCONSTRUCTION4 жыл бұрын
Good job
@kanarajan4 жыл бұрын
TEMELTAŞ CONSTRUCTION thanks dr
@wuhansinorocktechnologyco.7184 жыл бұрын
Is it only necessary to purchase software and sensors?
@kanarajan4 жыл бұрын
I don’t understand; what do you mean ? ; no special software is needed ,
@Satyabansahoo5 жыл бұрын
What the design load of this pile. & Jack capacity
@kanarajan5 жыл бұрын
the factored load was around 6500 kN for this test, jack around 10000kN
@hunartaha830 Жыл бұрын
placing dial gauges on this plate is mistake
@kanarajan Жыл бұрын
Yes it is not recommended at all the occasions; the test load should be checked
@hunartaha830 Жыл бұрын
the main girder is very small
@kanarajan Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient
@kanarajan Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient
@kanarajan Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient
@kanarajan Жыл бұрын
I think, u couldn’t judge the dimensions of the girder by looking this video, but it’s successfully done and sufficient