Stock cam stock ls 5.3 on 250 shot nitrous

[@dieselapegarage]

Those 5.3 can take some abuse keep it coming 👀 🍿💪

[@CompetitorsEdge22]

Thanks, yes they can!

[@lancelanphier9509]

Nice.... What was your ET?

[@CompetitorsEdge22]

thanks, it went 6.7s to 1/8 mile

[@YolandoSM]

Just curious boss, how much timing did you pull back on your 250 shot back then?

[@CompetitorsEdge22]

if I remember right, I pulled 12 degrees, ran it on 14 wide open throttle, I could have gotten away with adding about few back in but this was safe

[@bagwellpower2951]

I liked and subscribed, you have a killer channel. I ran a stock cam in my Ls1 ws6 car, studded and gapped with only a percision 78 with a glide and went 5.80's in the 1/8 on 22lb of boost. Everyone swore it had a mild turbo cam but it was stock. I hope to start making some better videos of builds on my channel. Check it out if you get time. thanks

[@CompetitorsEdge22]

Haha thank you, that is awesome! I subscribed to yours as well, look forward to checking yours out!

[@bagwellpower2951]

@@CompetitorsEdge22 thank you sir

[@CompetitorsEdge22]

on a 250 shot👍

[@cyclark8762]

what rear gear, tire size, and trans? and was the time 6.7?!

[@CompetitorsEdge22]

yes it was! 4.10 gears, 28x11.5x15 and th350 with transbrake

[@xploration1437]

Where is this?

[@CompetitorsEdge22]

this was in altona, mb for their charity drags.

[@joshuagause1620]

What kit?

[@CompetitorsEdge22]

it was actually a pieced together kit, nitrous works solenoids and a nozzle in the intake pipe

[@joshuagause1620]

What ring gap?

[@CompetitorsEdge22]

it was factory gap, I never added clearance to the rings but I did have the engine open and cleaned it, when I did that I check the ring end gap and it was .028" if I remember right

[@Tmays_]

What gear ratio is in the truck?

[@CompetitorsEdge22]

4.10 gears in this video