This is why the AVCS gears must be replaced or serviced properly. Alignment is key
Пікірлер: 18
@jsmaddocks82836 жыл бұрын
Thank you so much. Got the left and right codes simultaneously on a new engine build, and figured out both exhaust AVCS assemblies were binding (after losing sleep worrying about low oil pressure, oil contamination, etc.). I used a spare cam to check alignment during AVCS gear re-assembly.
@360Sebastian3604 жыл бұрын
Did you manage to fix the AVCS binding issue after using a camshaft for alignment?
@subarulegacybl5372 ай бұрын
Where can the o ring gasket be purchased
@waggaclint6 жыл бұрын
If this gear wasn’t reassembled properly could it cause a valve ticking type noise?
@rayleal21095 жыл бұрын
Quick question . So the pin/guide that's coming out from the block/cam into the cam gear slides in the half moon not between the 3 holes. Hopefully you understand my question
@rayleal21095 жыл бұрын
Any one?
@lagg-alot83086 жыл бұрын
You would make A LOT of MONEY if you made those tools and put them for sale on eBay. You could charge $45 each tool and sell millions world wide.
@mariopic4 жыл бұрын
so u have options for replacement bolts for the avcs sensor the 3 bigger bolts that are 5 point
@johncarstensen62354 жыл бұрын
Which holes do you apply air too in order to release the pin (plunger)?
@gerekappo9 жыл бұрын
Nice video!!! Theres a SPRING on the exhaust pulleys on STi engines (09+). A friend of mine need TWO of these. Do you know where i can found them? He tried all over the internet and only found them both new (pulleys). Not just the springs! Thanks in advance!
@360Sebastian3604 жыл бұрын
If you are in the USA find a car with AVCS in the junkyard ? Try a salvage yard, or a part out on facebook marketplace, craigslist, or offerup.
@johnmurphy85305 жыл бұрын
What's the cam shaft measurement
@srhabb7 жыл бұрын
You service FA20 gears?
@outfrontmotorsports7 жыл бұрын
We do not currently offer FA20 gear servicing.
@_Epictetus_5 жыл бұрын
Why not sell the tools?
@360Sebastian3604 жыл бұрын
try using a regular camshaft and making the compressed air test tool out of wood or something,