Subaru EJ25 Short Block Assembly Part 2

[@John-rw9bv]

really detailed, clean and well edited - top job again :)

[@johnhannemann4006]

Thanks for the video. Hey, what about the checking the gap and filing of the piston rings? Did I miss that?

[@SWSpeedCo]

Thanks, glad you liked it. Here is the link for the ring gap video I made kzbin.info/www/bejne/qqrXlaqujN2Sr68

[@tyler62682]

You fast forward to C clip part

[@Socal_Scene]

Why you didn’t check the piston ring clearances?

[@SWSpeedCo]

I did in this video: kzbin.info/www/bejne/qqrXlaqujN2Sr68 And I did the plasti guage of camera

[@mgrotel]

Did you put sealant on the wrist pin plugs or is it not necessary?

[@SWSpeedCo]

I put sealant on them for good measure. There is a crush washer that is supposed to go on there too, but I used a little sealant on the threads as well just for added insurance.

[@saj2st]

Hi I have legasy 1997 withe problem transmission no fwd

[@jaynunez3988]

So we could use the arp fa20 flywheel bolts on the ej?

[@SWSpeedCo]

Yep, they are the same thread pitch and length

[@tyler62682]

You fast forward the C clip pray

[@mendozachild135]

What did you torque the wrist pin plug to?

[@SWSpeedCo]

50 foot pounds

[@JonathanHernandez-if6qf]

Can the case halves be powder coated??

[@SWSpeedCo]

I think so, it would be a lot of work to make sure all the holes and faces are covered.

[@JonathanHernandez-if6qf]

I’m in the process to buy the bottom end and rebuild 2018 EJ257