They never mentioned anything during tuning, so I’m guessing it was fine with just the boost controller
@10MMsocketfinder3 жыл бұрын
Good video, next time use silicon spray to slip on the hoses much easier. 👍🏽
@rmcustom9573 Жыл бұрын
Silicone is a very bad idea, as it does not dry and/or evaporate. Therefore it stays very slick, leaving your fitting loose & prone to leaking. If anything, use a SMALL amount of WD-40, which will dry up from the heat of the engine, leaving an air-tight seal & a snug fitting. Ultimately, you want the hose to go on hard & dry.
@YeahWeSmokeGood10 ай бұрын
That intro sounds familiar. I can't remember what song it is tho.
@TonyTheTruckGuy10 ай бұрын
Parkway Drive - Karma
@soulgado85372 жыл бұрын
What diameter hose did you use?
@TonyTheTruckGuy2 жыл бұрын
Honestly I’m not sure what diameter the hose was, it came with the boost controller.
@brycegurno92115 жыл бұрын
When i hooked it up this way it was just at wastegate pressure
@TonyTheTruckGuy4 жыл бұрын
Sorry for the late reply, 300+ comments were "being held for review" for some reason. I believe you will need a tune to have better control over it.