This video is serendipitous GOLD for me! I previously ordered the V3 of this motor last week before I discovered your channel. Motor arrived yesterday and windings look great. Plan is go wait until the motor dyno arrives an do some test comparisons from your original research using 80A speed controllers from Z, Sky Lord, and Spektrum Smart. I previously ordered 2 Mini-Uproars last month....one will be built with this power, while the other one awaits future long-term power advancements. The Mini-uproar will be my mule for rippin up the skies with balsa. Hmmmm...maybe I should order a couple more Mini’s for those unexpected gusts of gravity or occasional dumb-thumbs syndrome. Thanks for posting, it is very much appreciated! Jim
@RCVideoReviews4 жыл бұрын
Those v3 motors look very very good. I want to use one on my next project. I've looked at that Mini Uproar a couple of times too. Have you flown it yet?
@WTJimmy4 жыл бұрын
Have not assembled the Mini-Uproar yet. Still trying to determine best type of servos to use. I am not a 3D pilot, but I’m looking to use both 3S and 4S power on the Mini. Just want the servos to hold using 4S during windy days with high throws, and spoilerons.
@RCVideoReviews4 жыл бұрын
@@WTJimmy They recommend an overpriced Spektrum 20g servo. Check these out: hobbyking.com/en_us/corona-cs238mg-metal-gear-servo-4-6kg-0-14sec-22g.html
@WTJimmy4 жыл бұрын
Thanks John...These servos are perfect and I ended up ordering 5. These represent a 64% cost savings over the Hitec. For the Mini-uproar, I’m going with the Detrum SkyLord 60a ESC, and the Detrum 8 channel (mounting orientation reqt). A complete Mini-uproar build purchase comparison between Tower and The Web is $369 (Tower) vs $213 (Web). Yes....your research and sharing of this information is very much appreciated!!! Jim P.S. The Rimfire .15 is almost 2X the cost of this motor....and not available until “Mid-Oct”.
@RCVideoReviews4 жыл бұрын
You'll be very happy with Sunnysky and those Corona servos get pretty strong reviews. Good choice ordering a spare. I ALWAYS add one servo to the order. Also good job doing the shopping. You are on to my strategy.... ;)
@TheGraemeEvans3 жыл бұрын
The master airscrew props tend to have slightly less pitch in my experience. On a static test like your running you are not measuring airspeed. But you will see similar static thrust with less amps because of that. But the APC will have more pull in the air.
@koko-wt1ub Жыл бұрын
I’m looking at a sunny sky v2 or v3 2814 for my 1.1m T28, I want to run a master air screw 9 x 7, 3 blade, any recommendations re what kv I should select and whether I should go with v2 or v3? Thanks!
@RCVideoReviews Жыл бұрын
Sunnysky does a great job (but not perfect) of posting motor test results for various configurations on their site. You didn't provide voltage/amperage information, so I can't make a recommendation, but if you go to the Sunnysky website and look at the different Kv options, look at the motor test data to sort it out. General rule of thumb is you can give up pitch or diameter for an additional blade. So if you see something that works in a 10x7 2 blade, that should give comparable results to a 9x7 3 blade.
@koko-wt1ub Жыл бұрын
@@RCVideoReviews thanks, I’d be running on 4s, the weight of the plane is 1260g. I have upgraded to a 70A esc as I had one lying around. I’ll check the website again, but would appreciate your thoughts
@koko-wt1ub Жыл бұрын
@@RCVideoReviews after looking at the website, I’m thinking v2 (black version), 900kv, as at a 1300g flying weight, that should be more than enough thrust?
@rafaeltorres28862 жыл бұрын
my only gripe with sunnysky is that now they're so popular they can't keep up with demand.
@jeferssoncachone43183 жыл бұрын
Esses Motores Sunnysky 2814, é recomendado para qual envergadura de aero?
@RCVideoReviews3 жыл бұрын
El tamaño del motor no depende de la envergadura. Especifica motores según el peso de la embarcación. Mire este video: kzbin.info/www/bejne/iKu0pamJZtB_irM
@MrZeek1014 жыл бұрын
What a beast I have v2814 700kv 4s on my 1800 Skyhunter great motor 3.8 amps cruise speed long range for crop inspection Oh and your chicken scratch is because your using the wrong hand lol great Review Take Care
@RCVideoReviews4 жыл бұрын
I'm straight up impressed with this little motor. I think when you guys see it on the plane you'll belly laugh. You're probably right about the wrong hand comment. I've never been able to write straight. Thankfully in this age we can type more than write or I'd be in real trouble. Long range crop inspections you say? How long are we talking here?
@MrZeek1014 жыл бұрын
@@RCVideoReviews 14 miles out is my personal record it would go further but I dont want to lo Yet
@RCVideoReviews4 жыл бұрын
That's pretty strong. What are you using for Tx/Vx? Did you see my antenna tracker video?
@MrZeek1014 жыл бұрын
@@RCVideoReviews lol which one I have 7 long range planes 4 long range quads from Pix Hawk to F7 Mamba some on Crossfire a few dragon link immersion long-range Vtx 2. mw Two Opterras two Skyhunters one MFD and UAV MQ predator 3m
@jeferssoncachone43183 жыл бұрын
Os Motores Sunnysky são melhores que os motores da T-Motor ?
@RCVideoReviews3 жыл бұрын
No estoy seguro de entender tu pregunta. Si pudiera elegir entre las dos marcas, buscaría Sunnysky primero, aunque t-motor es muy bueno.
@arvingarcia55844 жыл бұрын
what do you think if i use a 8x6x3 propeller to this? do you think it will produce higher thrust or lower? or the same in the video? thankyou for the anwer. btw. thanks to this video. its really help us . keep it up sir.
@RCVideoReviews4 жыл бұрын
If you compare the thrust to pitch changes, here's what I would expect to see with that swap: - Thrust about the same. You've gone down an inch in diameter, but added a blade. So I think thrust will stay close. - Speed will go up some because your pitch changed from 5 to 6, however, since you've added an entire extra blade, I don't think the speed will increase as much as if you stuck with a 2 blade because you've added more mass. Net effect of this is thrust is probably close to a wash, speed will increase some, amperage and watts input will increase. That said, I would measure with a watt meter. Results aren't always perfectly predictable. I shouldn't have seen prop stall on the 9x6 but it's the only explanation anybody came up with for the lower power development in this test.
@arvingarcia55844 жыл бұрын
@@RCVideoReviews thank you so much sir. very well explained :D
@JohnHopke4 жыл бұрын
arvin garcia you’re very welcome. Let me know what you find out.
@SILVIOFRANCO14 жыл бұрын
I only use those. Thanks for sharing. Nice Job!
@RCVideoReviews4 жыл бұрын
You've cracked the code then. They are really good motors and the price is icing on the cake.
@spiewie14 жыл бұрын
can i use this motor to replace my nitro 8.5 cc engine? on a 1.5m wide plane? of balsa wood?
@RCVideoReviews4 жыл бұрын
As much as I'd like to answer this question, I spend a little more time on motor choices. Have you looked at my video on how to design power systems? kzbin.info/www/bejne/iKu0pamJZtB_irM
@charliemarchiony79144 жыл бұрын
Could you review the E-Flite BL15 motor from their 1.2m warbirds? (EFLM4115)
@RCVideoReviews4 жыл бұрын
Hi Charlie, That one kind of goes against the grain for me. I normally buy and review motors that fit with the airplane review plan I have. If you'd like to send one in for testing, I'll put it on the stand. Otherwise, if I were in the market for a .15 class motor, I'd be looking at Sunnysky.
@RCVideoReviews4 жыл бұрын
Agreed.
@airhammer62034 жыл бұрын
Like the test videos, the different battery and prop combinations are interesting to see. I'll look Sunny Sky up, just to see the prices. AirHammer out!!
@RCVideoReviews4 жыл бұрын
They've impressed me quite a bit lately. Good motors. Glad you like the test vids. I'm surprised they don't get more views.
@claygrigsby12802 жыл бұрын
I just came across your channel and really enjoy it. What all did you use to build your JUDGE, I would really like to have one of them for my planes. Great channel!!!!
@RCVideoReviews2 жыл бұрын
I used this: hobbyking.com/en_us/turnigy-thrust-stand-and-power-analyser-v3.html But it's discontinued at HK. They just white labeled it though. I think it can be found as a Racestar, or Trackstar, or something like that.
@johnstahl10464 жыл бұрын
Nice motor. That Flitetest motor same price and lower on power.
@RCVideoReviews4 жыл бұрын
I was speechless and as you know that doesn't happen often enough. ;)
@SIDI-RC4 жыл бұрын
The company has released a new series of engines version 3, claiming that the utilization is 30 percent higher, suggesting that you do a test for this series. SUNNYSKY X2216-III 1250KV
@RCVideoReviews4 жыл бұрын
I will look for an opportunity to do that. I've heard this before on the v3 motors.
@ZuNunchaku Жыл бұрын
when you said holy smoke, I thought the motor was burned
@RCVideoReviews Жыл бұрын
Hah, nope. It's just an interjection.
@Gordar124 жыл бұрын
Чучело - учи русский !!!☝️🧐
@RCVideoReviews4 жыл бұрын
У меня около 0,0001% русских зрителей. Зачем мне учить русский?