SUSPENSION MODS AND TESTING / BUDGET 190E DRIFT PROJECT

[@sirseanisrobinson1515]

Thanks for Sharing the modification. I'm Building a 190E Drift car as well

[@driftinrust]

Very cool! Let me know if you need any help!

[@matiasrivas8251]

nice mod for the lower arms to get more steering angle!!!!!!, the cam on the side its awesome!!!

[@driftinrust]

Thank you!

[@Johncock090676]

Nice. Need to make some new lower arms for mine still not got enough camber.

[@driftinrust]

You should!

[@junitomaster6689]

what did u said about tie rods, extendes by how much? 4:52

[@driftinrust]

2.25 inch

[@Wrofeel]

Nice

[@driftinrust]

Thanks

[@alotofmewaslostinyou4493]

Awesome video, soon will be doing the same to mine, with how much did you extend the tie rods and lower control arm (sry didnt manage go hear it in the video, music was a bit too loud) and with how much did you shorten the knuckls ?

[@driftinrust]

Yeah a bit too loud i left the music sorry. The LCA is 2 inches longer, the knuckle is cut right after it becomes thiner( you will see what I mean when you look at it) and then flip it 90* and weld it. The tie rods are 1.5inches extended.

[@TorretasGarage]

How does it feel afterwards?? Mine has a ton of Camber in the rear by lowering it and drifts really bad 😞

[@driftinrust]

Front has 6 degrees of negative camber, back has only 1 degree of negative camber. It feels really stable and the steering angle is amazing! The car slides really well and can hold a good slide. Towards the end of the day we had a lot of close drifts unfortunately GoPro ran out of battery! Next days is 23rd this month. Hopefully more tandems!

[@bernardwarr4187]

You can extend the top arm to reduce negative camber on the rear, if you need to

[@rafag3734]

hello what is your font bumper?

[@driftinrust]

It's bmw e36 standard bumper.

[@HugoNonmoira]

❤

[@driftinrust]

👌

[@Bu_-ij2mp]

what about diff

[@driftinrust]

Welded stock 2.0 diff