Im letztes jahr vergaser gereinigt. nicht rihtig schwimmer eingestellt. Immer benzin verliert in stand zustand. Aber jetzt schon alles in ordnung.
Пікірлер: 19
@viktorpolle5572 жыл бұрын
Золотые у тебя руки
@jimrowe41772 жыл бұрын
I recently purchased one with 8,000 miles on it. Cleaning everything and getting new tires.
@Stealyourtone2 жыл бұрын
Just bought my gsx1100f! Had a fun ride with it. I love the edit man. Goodjob 😁
@motoauto82 Жыл бұрын
gute maschine. mir gefehlt.
@Stealyourtone Жыл бұрын
Currently took mine apart! One small tip cuz my carbs where overflowing. Make sure to take off the floats and clean/replace the ‘float needle’ and the little half round filter underneath. Mine where full with dirt. Great video btw made taking the carbs off and back on much easier for me!
@motoauto82 Жыл бұрын
thanks sa advice. I have changed needles before. misconfigured floats. in this video just corrected my shortcomings
@jasonwitt15142 жыл бұрын
"Vergaser einstellen" Titel verfehlt
@motoauto82 Жыл бұрын
kann schon alles in video sehen was brauchen.
@CampeR33Ай бұрын
Hello, What is the normal position of the fuel tap?
@user-ed1ft6mi1r Жыл бұрын
Suzuki Power! Сузуки Сила!
@aka_sharky2 жыл бұрын
I recently did the jets and floats in mine and now it wont start
@markbrandon53532 жыл бұрын
Be very careful that you don't miss to install the vacum hose
@motoauto82 Жыл бұрын
there are many moments where it is powerful to make a mistake. from diameter to screw turn
@YS-qk6cm Жыл бұрын
I love katana, and just opened my carb and cleaned it but I dont know how many turns should I turn jets and screws🥲☹️
@Stealyourtone Жыл бұрын
Have you looked up a manual? Also while disassembling make sure you count how far they are out. What I do is take pictures of each screw and screw everything handtight, make sure you count how many turns they have to get out of that position. Don’t know if it makes any sense what I’m trying to say but there’s many videos out there telling you how to adjust carbs. A manual helps as well telling you how many turns each screw should need for standard settings!