Suzuki Quadrunner LT230 Mikuni Carburetor Ruined, PZ27 Clone Swap!

[@TheShadeTreeFixitMan]

I'm not sure why some folks are so concerned about being "original". It's more important to get it running and useable in my book. Nice recovery Harvey.

[@ndafarachaitezvi1139]

It's always a pleasure to see another great build coming to life.Your wealth of knowledge and problem solving is quite extraordinary.Thanks for being such a great teacher and for sharing your knowledge with us

[@bangs2ndshotgarage865]

Man I like how you made your own intake. That’s a big problem I run into with older quads and bikes and nobody makes replacement ones. You would think with 3D printers and all the modern technology someone would make them as there’s def a need and market for it.

[@martinburgess4814]

Great job Harvey .i may have flared the flange or put a ring on the manifold adapter.but thats just me. All the best to you all.Keep em rolling rolling

[@donaldhalls2189]

That sounds good I recon you should finish it off be nice all the best to you and all your loved ones

[@timclark2887]

That runs very nice, good score!

[@jamespalumbo3277]

Bravo harvey another bike saved from the land of misfit toys

[@off-roadpapa2422]

Running good

[@Cameronguitar444]

I literally just found LT300 sitting for 10 years started right up but the choke plunger was ceased so I drilled it out ruined the carb....Bought a 36 dollar replica on Amazon runs like a top.

[@atvseatexchange2176]

It sounds like a challenge was accepted, my job here is done! Can't find a listing on Mudthrowers for the front lug spacing and tire size, only the rear. Harvey, see if you can give me a measurement on the front lug spacing and I'll see what other wheels might fit.