Syncing a Powrtouch Motor Mover Handset

In today's video, Chris shows us how to sync/re-sync the handset to a Powrtouch motor mover electronics box.

[@tommckernan7706]

Thank you so much for that.

[@christhecaravanman2589]

🤘🤘🤘

[@sionny2009]

Hi thanks for all the helpful vids. I've bought a twin axle caravan with a single powrtouch evolution move on but want to fit the same mover from my old van to make it awd. Can I pair 1 remote to the 2 boxes and is it the same procedure? Thanks again 👍🏻

[@christhecaravanman2589]

Hi, sorry for the delay in replying. Yes you can. The boxes are identical so receive the same signal it’s just the wiring to the motors that is different.

[@Steve.Mandy64]

Hi could you help my powe touch evolution all wheel drive not turning left or right but will go back and forward

[@bernadettesheppeck944]

Hi Chris, I have the same system. In the remote however , only a tesco 9v battery will work. i have tries duracell, and two other good brands. All batteries had plenty of power , tested with my voltmeter. have you come across this before? I have also bent slightly the contacts in the remote thinking this may help, but to no avail. The tesco battery is slightly bigger in size which must cause it to fit better and therefore work. Regards

[@paulphillips7308]

Hi Chris,when I sync my remote I get the green and red light flashing and remote goes through the set up until the right hand green led is steady, the green light on box is steady but when I press a button on the remote the red light doesn't flash and you can't hear the relays clicking this is the same with the umbilicle cord connected,would this be a remote or control box issue,many thanks Paul.