Talon sub trans removal and diagnosis Honda transmission issues no reverse in transfer case

Have questions? join my patreon page!
Patreon:
/ mudpuppyoffroad
For gear reduction installs in central FL email me at: [e-mail]
Terache Aztex 5% off promo code: MUDPUPPY
www.terache.com/products/azte...
Demon axles promo codes:
www.demonpowersports.com or call
15% Off Coupon Code “MPUPPY15” for all products.
5% Off Coupon Code “MPUPPY5” for X-Treme Axles & Power Steering Kits
@demonpowersports

[@limegreen192]

Thank you for this video! The stud removal is key. I had it out in less than 2 hours using a hoist.

[@h300ex2]

Love all your videos keep up the good work bro love when you pull things apart and show how to fix them

[@Mattism78]

Nice. I pulled mine just by moving the front diff and carrier bearing. Trickiest part for me was setting the timing correctly on the shifter. Once I got a proper manual it was fairly easy.

[@MudPuppyOffroad]

I just put it back in a few minutes ago getting that timing wasn't too bad. Driveshaft was the trickiest part barely enough room with the winch bracket

[@tyleradams6002]

Amazing how much damage one tiny little vent line being frayed thru can cause...sorry for your loss

[@TheBeatenTrail]

great video, very informative. Honda replaced my subtrans at 49 miles under warranty. Low never worked.

[@itsgatlin4035]

Nice, those talons are a great SxS if you take car of them, as of most SxSs

[@Jaxon1127]

Nice Kubota, I’ve got a MX5000 with front end loader. They are great tractors

[@ryanplessel8911]

Were you able to put it back together I could use some help. I can't figure out how to set the shift gear. Or where can I buy a hole sub trans

[@krisvitt2231]

The back small shaft behind the sub trans how did you remove it ? I’m now having to remove mine to save cost.

[@fredlawson1819]

How do you get the front driveshaft unhooked from the sub-transmission I cannot figure out that snap ring

[@MudPuppyOffroad]

Yeah it's a pain in the butt it's easier to undo those three 10 mm bolts and leave the back half of the differential in the bike

[@mattaltman6344]

Hey man is it normal for a brand new Honda talon 1000r to have noise from sun trans when it switches gears in at mode like a clunk sound it’s brand new took on first test run and sound has me concerned

[@MudPuppyOffroad]

By brand new, what year do you mean? Also, this is a very noisy transmission. Most people here the clutch and the gears swap but that's not in the subtransmission

[@mattaltman6344]

Sorry had sub trans oil on my mind earlier it’s a brand new 23 1000r 2 seater I bought from Honda dealer this past Saturday was a left over model

[@goldengatchalife]

building a 350d foreman, 14 in lift an 16 inch stretch. Would you recommend a %76 GR or %115 for 37s-40s?

[@MudPuppyOffroad]

115

[@funtimeonline8071]

Why would you not drain it before hand? Correctly.

[@flacracker4649]

I think I figured out what happen to the Sub transmission breather line it rest up against the radiator hose I think that possibly burnt it up I can’t upload a picture but I just caught mine in time and that’s where it’s rubbing on an can see where it’s starting to melt

[@MudPuppyOffroad]

If your coolant is hot enough to melt plastic you have a bigger problem... Water boils at 212

[@flacracker4649]

@@MudPuppyOffroad gotcha I thought that could of been the issue

[@flacracker4649]

Might be a crazy ? But can the vent line handle the heat from the radiator hose just curious

[@MudPuppyOffroad]

Yes

[@adenbeaugez5055]

The guy who built your portal brackets, does he sell them regularly or did you just have them made? Work at a dealership and have a few customers asking. Thanks

[@MudPuppyOffroad]

He makes big batches

[@adenbeaugez5055]

Thank you! Does he have a website or phone number?

[@MudPuppyOffroad]

jbcoffroad.com

[@riym07]

early?