Taran tactical base plate problem

[@Chris-od4ie]

You literally saved me on this one I was getting mad. I could get the bullet in but it sure as hell took a lot of force. I did what you said with spring now it goes in with ease thank you so much.

[@cesarmaldonado73]

Had the same problem with mine. Did the exact same thing you did by using Glock stock spring and it works perfect now.

[@roberttaylor619]

I CANT LOAD THE 7TH ROUND IN THE +1 ANY SUGGESTIONS

[@moebiusmodels]

Same problem this weekend. Pulling all their springs to see if it helps me as well! Quite a shock thinking you're getting something so well regarded and end up with a mag full of loose ammo in the middle of a class. At least it was a great teaching experience on a few levels. 1 - EDC don't play with mods. 2 - Anything can happen at any time, regardless of how simple. 3 - Tap and rack don't always fix the problem, practice with different failures!

[@ElJoeRN]

Same problem. Factory spring solved the issue.

[@PlugNuster]

Extra capacity base plates can get you killed. For range shooting ok. For EDC no way. Stick with the factory mags as they are. Just carry an extra mag with you. It's not worth the risk IMO.

[@andrewrandol3648]

I'm having opposite problem with TT+2. Last round almost always fails to feed. Not hard to get last round in for me. Maybe TT tried to remedy problem you were having and went too weak.

[@vbstangin]

Hmmm... Maybe they had enough complaints. I never called em tho ...i just swapped springs ...it worked...im happy ...lol

[@vbstangin]

I haven't tried the +3 yet... I would order one but So far I have no need, as I use this for concealed carry... I just carry the plus one in the gun and the plus two in the pocket for "just in case" scenarios. I'm a big guy and Ive found that the bigger the gun... The more uncomfortable the carry. Soooo I try to keep it as small as practically possible.

[@68Lima]

Mostly same problem, rounds where so tight I couldn't rack the slide from the +1 and +2 baseplates. I sent them back to Taran and they said they are working now and that they replaced "a spring". Probably the +2 I'm guessing. Still have to test it yet but I can rack the slide now even though still a little tight.

[@68Lima]

Update: Tested the +1 more because I want to carry that one. It appears to be working and feeding no problem. Put about 75 rounds of Federal HST 147gr and 50 rounds of Winchester whitebox 115 FMJ. No issues and the +1 seemed to actually loosen up a bit after running several mags, the seventh round is a little easier to load. I've seen alot of chatter on different forums about Taran Tactical baseplates and G43s. Some people say they are flawless from installation and a few report similar issues. Saw a post where one guy had two G43s and one ran perfect from the get go and the other had feeding issues with the same Taran extended mags. Educated guess: either Glock 43s are leaving the factory with ever-so-slight variances or Taran Tactical baseplates are. I'm betting on the latter.

[@NicR94]

I have the same problem. Have you had any recent problems with the stock spring being in the +3?

[@vbstangin]

NicR94 i didn't realize they had a +3. Lol I'm gonna have to check it out now

[@SmoStyle]

NicR94 i have the same problem

[@clatham1021]

I have the same problem on my 43 with the +3

[@wronghandedretrieve7132]

@@clatham1021 I have the same problem with my +3s. Switching back to my factory Glock springs. Hope that fixes the issue.