TC Hawken and Renegade Take down video

[@OntarioPrepper]

Thanks for sharing this. great information and is easy to follow and understand ❤

[@Porky186]

Thank you Ron, love all your videos…shorty

[@straightpipec6099]

I was wondering how the lock came out. Now I know. Thanks

[@chuckrossi]

Thanks that well help me a lot since I am new to black powder shooting.

[@idahoron]

Your welcome. I have more videos on cleaning and shooting. That you should watch. The one you should see first is " Shooting and field cleaning a traditional muzzleloader"

[@rickharbridge1813]

Good video dude I liked it I just bought that gun

[@shaunsian4784]

Was that an aftermarket barrel or did sand it or polish it to look stainless steel like

[@idahoron]

That barrel is a Green Mountain LRH stainless steel fast twist barrel. It's aftermarket.

[@chuckrossi]

I like your peep sight, where did you get those?

[@idahoron]

The front sight is a Lyman 17 SML with Lee Shavers BPCR inserts. The rear sight is a Lyman 57 SML peep.

[@albertmajerus6483]

Hello Ron. I have several TC Hawkens in with Green Mountain barrels both LRH and round ball twist. Please, I would like to know what make and model recoil pad you have used on the “Hot Rod Hawken”. Thanks, Al M

[@idahoron]

That is a limb saver grind able. It works great

[@albertmajerus6483]

@@idahoron thanks Ron! What size?

[@Montananmooselover]

@@albertmajerus6483poor man it’s been three years still no answer

[@G56AG]

I'm having a problem with my TC Hawken percussion lock, the hammer will no lock back at full cock or half cock. So far I haven't found any info on the lock so I don't know exactly what is going on. I bought this rifle when they first came out but its been sitting for several years and I'm stumped as to what is going on.

[@scottbrightman3662]

Hello, I just put a Lyman receiver sight on my renegade 54 caliber percussion. I was just wondering if you can give me some advice please on how to site in this site. And I’m hoping it’s not too complicated and I’m hoping also it’s easy. thank you

[@idahoron]

So let me see if I understand you. You have a Lyman peep sight on your Renegade. Now you are inquiring how to sight it in. Is that correct?

[@idahoron]

Did you install a Lyman front sight or are you using the original TC Renegade sight?

[@scottbrightman3662]

That is correct. I’m just wondering if I should put a Thompson center front site globe on it as well?

[@scottbrightman3662]

@@idahoron I had installed number 57 receiver site by Lyman. From track of the wolf. Which, by the way, is an evil place. I can plank down a wad of cash and still be in thousand dollars in debt. Lol.

[@idahoron]

@scottbrightman3662 I installed the Lyman 17aml globe sights on several rifles. I use Lee Shavers BPCR inserts. You might need to shim the front of the Lyman 57sml peep to get it to travel vertically a bit better. On some tangs, they tend to lean forward a bit. Sighting in is pretty straightforward. Start at 50 yards and shoot.

[@chrisbaker528]

how do you clean the inside of the barrel?

[@idahoron]

Watch my video on fully cleaning it. kzbin.info/www/bejne/jabEmmCOfLeGpM0