One last thing to add is if you have the stock retainer, you will need to slip that onto the axle shaft before you install the new bearing kit. If you have an aftermarket retainer, then you can put it on later down the road. Best of luck to those who try to tackle this!
@StephenTymmons7 күн бұрын
Without a retainer plate on there before the bearing pressed on...how does the axle stay in the diff
@RacerRoss8 ай бұрын
Thanks Mitch!
@vincentbryan19625 ай бұрын
Thanks for this video !
@tabcobra Жыл бұрын
Most of the whining noise in my car come from the passenger seat where my wife is sitting!
@timhouts63124 жыл бұрын
Nice job Mitch keep the video’s coming hope to see you guys at super celebration west my bronco and I have been out of action for a couple years cancer treatment can’t wait to get back out there say hi to your dad hope to see you on the trails.
@wildhorses4x44 жыл бұрын
Thanks, Tim! As long as the world doesn't end before Super Cel West, we will definitely be out there!
@BDGumby0074 жыл бұрын
Mine sounded like popcorn when they went! 😜😏😎
@wildhorses4x44 жыл бұрын
I think that's a good thing haha
@BDGumby0074 жыл бұрын
@@wildhorses4x4 they pressed off and on pretty easy of coarse I had a full blown machine shop at my disposal at the time! 😏
@welndmn4 жыл бұрын
It’s also important to note the early roller bearings (not tapered rollers) the seal is in the housing, not on the axle.
@chriscoffey6667 Жыл бұрын
I have the tapered bearings. I had to take them back to the shop twice because they’re leaking. Now, I have to do it again. Is there anything a specific I need to look for on the axle. Pulled the axle, and race is stuck in the axle tube which I think is fine. I just need this to stop leaking.
@welndmn Жыл бұрын
@@chriscoffey6667 if you have a habitual leaker, you need to check if that housing is straight. Sadly, most are somewhat bent from being 40+ years old.
@chriscoffey6667 Жыл бұрын
@@welndmn thanks for the reply man.
@Sharky19653 жыл бұрын
Do you have to remove a race from the axle housing now that you are not using tapered bearings? How does that work?
@hankfink3 жыл бұрын
No, but unless you know for a fact they're set20 Timkens, mixing and matching is probably not a good idea. Just leave the race off the new bearings. Often though they have a different style. You can definitely rent the tool to pull the races at parts stores like O'Reilly's and Autozon
@ChetGardner-iw3th11 ай бұрын
Dis the new one a tapered bearing
@jasonstrout45024 жыл бұрын
It's really a sad world we live in when KZbinr's have to add a disclaimer to their videos.
@wildhorses4x44 жыл бұрын
😂Yeaaahh, it is what it is. We would just rather warn people that it might not go as planned. That's with anything Bronco related haha
@hankfink3 жыл бұрын
@@wildhorses4x4 They don't have to, as anything on KZbin is 'entertainment'. Kinda like Fox New's defense.