Installing a 3d printed grommet for instalation of the terminator X max through the firewall of my nova
Пікірлер: 6
@VinoRatRodbuilds Жыл бұрын
Worked out great. 👍 I put a ECM in that location before behind the glove box area worked out well.
@OldCarGarageUSA Жыл бұрын
I like it, has a clean look on the firewall.
@rms1990 Жыл бұрын
looks good, but I would have just marked where the holes in the bulkhead were and used a step-bit where the harness would have gone through the firewall instead of cutting the whole center out. just my opinion, but works out either way, and that's all that matters! :D
@factoryratgarage Жыл бұрын
The hole has to be way larger due to the size of the connections that go through. The plugs are 1-1/4 wide, if I would make two holes that size it would leave a sliver in the middle, so I cut it out.
@rms1990 Жыл бұрын
@@factoryratgarage you know what? I have the same Terminator x max setup and I didn't even think about the connectors LOL I take back what I said! :D