Why would you do this installation video at night without not lights?
@arceor7942 жыл бұрын
I just did this and there is a much, much, much easier way to do this without removing the tail lights or partial removal of the bumper. Remove the plastic surrounding the trunk latch and pull back the liner to reveal rubber grommets. Fish the wire through the holes. Remove the rectangular access panel and you'll see the wires hanging down. You can fish them through the middle hole where the reflector sits. I did it in about 15 minutes.
@kelvpoon2 жыл бұрын
Looking great especially when it’s breaking
@nailars91472 жыл бұрын
Why did the bumper lights flicker at 12:25 when you applied the brakes? This would be a concern and considered a distraction for drivers behind you. Is this a bug from Hansshow or normal behavior? Thanks for the video.
@ProjectGTGarage2 жыл бұрын
Its a normal behaviour. This actually alert the driver behind you that you are braking
@paulmcfawn2 жыл бұрын
They look good. How did you remove the original reflector from the bumper?
@ProjectGTGarage2 жыл бұрын
I use some pick tools and trim removal tool a to get it out. Its only held by 2 plastic clip I place
@royc39782 жыл бұрын
So why remove rear light? And what path did you take with fish wire?
@ProjectGTGarage2 жыл бұрын
I run the wire through the gap of the bumper from the bottom of the tail light to the lower bumper. that clip was lost somehow..