Testing a Relief Carving on the MPCNC Lowrider 2

A quick video shot on my phone back in February. Wanted to test the relief carving feature with Estlcam on my MPCNC Lowrider 2. Unfortunately, it was sub freezing temps in the garage so I ended the project early. Still looks promising!
Estlcam: www.estlcam.de/

[@scratchbuilder5952]

Very cool to see…. Showcases the accuracy of the low rider and your setup Thanks for taking to time to post this…

[@figsgraphics5930]

Hello Brent, I'm a graphic designer and I'm in process of starting to buy a cnc, and I thought it will be an easy thing to do but it seems very confusing. Any advice where to start?

[@brentvecchi4893]

It’s really not that hard to figure out. GD software is much more complicated than CNC software in some respects so you should be Ok there. I built mine so I’m no help when it comes to consumer models. Just know what you are going to do with it before you buy one. They aren’t cheap!