Testing and review of the new Arccaptain Cut50 Plasma Cutter: Unboxing 2023

[@arccaptain-weld]

Thanks for the review, that machine is killing it in your hands!

[@robertkapostins6783]

Seems to work well

[@madgingercustoms]

Great job on putting this video together!!! Awesome job!

[@grumpyguys4082]

Seems to cut good. On my old miller, I add a paint gun filter between the air hose and the machine to catch water and make consumables last longer. used to use the round orange plastic ones but now using a clear glass one that you can see the water in it..

[@BigLou956]

Cut pretty good... I need to get me a plasma cutter for sure.. Did you buy that one or was it sent out to you for testing and review?

[@arccaptain-weld]

That's awesome! We actually collaborated, but it was an honest review. We didn't make any requests, but Jorge's cuts were really impressive!

[@Twindadx2_]

Hi there, Did you try it in 4T mode? I have been on the fence about whether to purchase because I wanted a pilot arch. From what I understand on 4 T mode you do not have to scratch start, it will run continuously until you click the trigger again. Beneficial to the open mesh cuts. Would love to see it in this mode

[@n8mail76]

what pressure are you running at?

[@rogertaylor8615]

Was it on 110 or 220

[@arccaptain-weld]

it's a dual voltage machine, but Jorge didn't mention which voltage he used though. 😅"

[@n8mail76]

220