installing a tsp cam on our buddy Jacobs 2010 Camaro this vvt cam is sick!!
Пікірлер: 43
@carlr.2322 Жыл бұрын
Njce job you make it look easy!
@dagorilla51772 жыл бұрын
Ahhh….!!!! I know tha feeling. That was funny: when you said: “they didn’t hook you up or nuttin like dat” lol
@Murdermaro817 Жыл бұрын
How much for the kit and what stage
@isaacperez123ify Жыл бұрын
What stage cam
@ThatsSoRaisin112 жыл бұрын
Sounds sick, what exhaust is he running?
@buildonemore2 жыл бұрын
All stock with no mid muffler
@sfranks883 ай бұрын
how much do you charge for this job?
@ryanwharton25313 жыл бұрын
How’d you get the timing cover off with those bottom bolts?? Mine are hitting some type of thick red wire. Any help?
@buildonemore3 жыл бұрын
There is a bolt that holds the red wire up because it's in a metal bracket take those two bolts out well take the bolt on the driver side out loosen the one on the passenger side it will pivot down enough to get the bolts off the lower cover
@ryanwharton25313 жыл бұрын
@@buildonemore thank you man!! I’ll tackle that tomorrow that was the reason I went inside for the night I got frustrated
@buildonemore3 жыл бұрын
@@ryanwharton2531 hell yeah man glad to help! Drop a sub! I'll do more diy in the future
@ryanwharton25313 жыл бұрын
@@buildonemore yessir thank you! And alright sounds good!
@Shelovesdevante2 жыл бұрын
Quick question I got my headers installed and now my remote start won’t work. But the check engine light is on
@buildonemore2 жыл бұрын
That's why the remote start will not work all gm vehicles will not function with cel on. Get the rear o2 sensors tuned out and it should start working again
@Shelovesdevante2 жыл бұрын
@@buildonemore also I’m getting Diablo tuning device you think they’ll be able to clear it and thanks btw!
@jeepTJMurdered2 жыл бұрын
Mopar is the same way. They start shut off within 30 seconds or less
@doaburnout12052 жыл бұрын
How much would you charge to install that kit? For a 2011 camaro ss also l99?
@buildonemore2 жыл бұрын
1500 labor. Kit cost was around 1500. So it would be 3k give or take
@ISTHTJAYY10 ай бұрын
@@buildonemore could you plz give the link to the kit
@EdgarPerez-gg2tl2 жыл бұрын
What was everything included in the kit
@buildonemore2 жыл бұрын
Cam/lifters/vtc lockout/headgaskets/timing cover gasket/valve sprung and retainers
@BlueBoyyyyyy2 жыл бұрын
Did this same cam install, did yours start up after the install?
@buildonemore2 жыл бұрын
Yes. It didn't like to idle but it was fine after the tune
@BlueBoyyyyyy2 жыл бұрын
Mine is turning over but won’t start, everything is back connected, except the harmonic balancer, and pulley system is not installed. New injectors installed, new coil packs installed. Any reason to why it won’t fire up?
@buildonemore2 жыл бұрын
Hard to say. Make sure the cam a crank sensors are plugged in. Go over all grounds
@BlueBoyyyyyy2 жыл бұрын
Ok thanks
@BlueBoyyyyyy2 жыл бұрын
I think I found the problem, I got shipped 42lb injectors instead of the stock 65lb injectors. Smh
@edgarp66442 жыл бұрын
How much hp did it make
@buildonemore2 жыл бұрын
It made right at 400whp
@richardgurtner7955 Жыл бұрын
I would like for you to do the same to my car*****I would gladly pay you 1500 to install this Texas speed kit in my L99, ******Great Job, I am ready to order the parts. where is your shop????
@ttgflavor4861 Жыл бұрын
Was this with the dod/AFM delete
@buildonemore Жыл бұрын
Yes
@ttgflavor4861 Жыл бұрын
@@buildonemore thanks did u have to get a new stall or can u use the stock one with no issues besides it fighting the brake on a stop lol
@buildonemore Жыл бұрын
@@ttgflavor4861 still a factory stall and it doesn't fight to bad
@ttgflavor4861 Жыл бұрын
@@buildonemore even if it was a bigger cam?
@buildonemore Жыл бұрын
@@ttgflavor4861 any bigger get a stall
@ceceh73692 жыл бұрын
How much hp he made
@buildonemore2 жыл бұрын
Right at 400 rwhp. The 6 speed cats make more power with a cam. The auto cars had the lower compression l99 6.2