The JTS M12 AR pattern shotgun.

[@markpippens6015]

I have one and the quality is outstanding......PERIOD !!!!

[@slickcyclic]

@markpippens6015 i completely agree , the only thing is , its a bit heavier than what I would like it to be. But other than that iv had zero issues with it. I plan on getting some 10shell mags in the future.

[@shanedennis1487]

The quality of mine was not. Aside from 10 rounds of 2-3/4l high brass, I’ve ran exclusively deer slugs. This thing was a fancy looking single shot. Every cartridge jammed, and looked like it had been chewed up by a pit bull. Gas setting changes made zero difference. I put hours of work into it, and a year later, it finally performs as it should have when I bought it. The bad part is, everything I fixed were zero dollar repairs. The ejector rail was razor sharp, literally cutting the brass lip, causing the jamming. 320 grit sand paper, lightly running it directly over that edge with each tear down has the gouging pretty much eliminated. Another issue, the TOP of the brass was form firing into the bolt carrier…..and it did that on all gas settings. Lots of cleaning and oiling of the gas block has helped that. I fully understood how the block worked and how to set it, not user error. The buffer spring may as well have been dipped in rubber cement, took forever to get the spring release to push down far enough to get the spring out. I’ve manually cycled the gun several hundred times, in groups of 50, then tear down, clean and oil again. Now it’s running deer slugs flawlessly on setting 2. If you don’t mind doing half the work that was not by the factory, and you have the time to do it, you can make it a decent gun. But, if I ever buy another one, it’s getting a full tear down before I leave the store with it.

[@slickcyclic]

@shanedennis1487 sounds like quality control issue with these cheaper Chinese shotguns i guess I must of got a good one , sorry to hear about your luck man.

[@shanedennis1487]

@ I bought it last October, I think price out the door was around $225.00. Even with the modified choke, it throws slugs pretty darn good, and it’s a fun gun to shoot. I’m no gunsmith, but if I can find the problems and fix them, there’s no reason for them to leave the factory with those problems. I’m not telling people to not buy one, just be prepared you might have to do some work to them.

[@3526900]

It was better when PSA had them for $200 there $300 now. It takes Remington choke tubes. To save your shoulder put a Limb Savor for $40. I would go have a talk to your LGS let him know you could have had it shipped to you for $318.99 + FFL fees. That's only $30 at my LGS.

[@slickcyclic]

@@3526900 hmmm noted