The TENDO E Collet chuck from Schunk

[@RichardDowd]

Very impressive - expected way more cost 👍

[@MTDCNC]

A very well priced system Richard.. Would you like more info from Schunk?

[@RichardDowd]

@@MTDCNC Thanks but I am a former machinist- I just keep up an interest :)

[@tomte47]

Can recomend them, we measured runout of about 2 microns and im not sure if that is the holder or spindle :) Only downside is the collets are abit expensive.

[@MTDCNC]

Thank you for your input !

[@alejandroleal22]

Do you have to use an intermediate sleeve

[@MTDCNC]

Thanks for watching.

[@alejandroleal22]

@@MTDCNC I can confirmed you can attach tools directly if your with in the tolerance

[@jim_osrs]

Best holders on the market!

[@MTDCNC]

Glad you enjoyed the video !

[@ArthurField]

The most common thing that happens after I introduce shops to these tools? They try them, and then they call to ask to get more.

[@MTDCNC]

Glad you enjoyed the video !

[@JohnCThomas24]

Hes wrong about one flute cutting on ER. He must mean an end mill holder

[@MTDCNC]

You will find on many ER's that the cutter is 'off centre' and essentially cuts on 33-50% less flutes.

[@JohnCThomas24]

@@MTDCNC if you have a radial engagement of .003 per tooth then your "off center" would need to be more than .003 in order for one flute to be cutting all the load correct?