Learn how to install Thermoplastic Universal Corner-Outside Corner with Johns Manville.
Пікірлер: 20
@MichaelGonzales-by1eo8 жыл бұрын
This helped me so much! Now I understand your standards. Thank you for the input.
@garrett31136 жыл бұрын
I am a roofer and see this done everyday. Had a good friend show me and it is very similar. Expect he welded more closely to inside for watertight and good seal.
@JavierGonzalez-pn1gk11 ай бұрын
This helpful for people like me as a apprentice
@joshchiappetta90137 жыл бұрын
thanks that was very helpful
@davidmauney41496 жыл бұрын
This was helpful, very much. But did it get probed?
@ivanibarra65426 жыл бұрын
Always tack weld . And please weld the middle . It’s not about the box moving it’s about water seals
@davidmauney41496 жыл бұрын
Heat speed and pressure.
@eastside04343 жыл бұрын
Couldn't this of been done with a small patch heated and stretched to fit.?
@evanlovesbears2 жыл бұрын
Exactly, saved the homeowner money, lowers bid, and works just as good if not better.
@bajatankpozarica6130 Жыл бұрын
A cuantos grado para soldar ese material
@Bryan-by5sb Жыл бұрын
No se quema específicamente por grados sino por niveles de calentamiento el heatgun tienes del 1 al 9 en la mayoría… para empezar se recomienda al 7; yo la uso al 8 ya si quieres ser más rápido le subes al 9 pero ahí ya quiere más experiencia pero ay muchos mas factores que también afectan.
@Diaz06205 ай бұрын
Uno mismo te vas dando cuenta pero yo te digo que es mejor 7 la mayoría de las personas note dice si le subes es más rápido pero hay otros tiene que subir los 9
@alexanderaldana44372 ай бұрын
Cuando se hacen detalles como ese es mejor en 6 amigo el 7vpuedes usarlo para membrana regular
@buckJuddson Жыл бұрын
I have never seen anybody use their fingers to roll it in 😂
@davidmauney41496 жыл бұрын
Looks a bit maybe. But if Karryanne don't catch it don't matter. You just do what the last guy tells you. On any job. Even brain surgery.. You'll get by.
@edho7584 жыл бұрын
Sloppy air pocket
@BRIANMASON12022 жыл бұрын
Hey, leave my wife out of this.
@bpebler2 жыл бұрын
Good - not great. Use a tool like a roller instead of fingers for transition changes since they’re the weak points, as stated. Add full perimeter tack weld prior to fully welding.
@BRIANMASON12022 жыл бұрын
Come on, who doesn't heat and mold with fingers??(not for EVERYTHING) Doesn't mean it can't check and be tight.you know how many times we pick up and put down that roller to do flashing? Any chance I can get to not keep killing my wrist and cause carpal tunnel worse than it is.....I'm doing it, it will check for, the inspector just fine.