This is how i fine tune

Editado por YouCut:youcutapp.page.link/BestEditor

[@jamesperkins343]

Just an FYI, the slug pin probe is not suited for pellets as the recess into the pellet is too deep. To get proper depth for pellets. Simply remove the barrel and probe... place the pellet probe into the chamber of barrel and align up holes....mark around pellet probe with a sharpe...re-install barrel and probe and close cocking lever and see where the mark you made aligns to... adjust probe depth accordingly. As for the slug pin probe, I have tried several different depths of the main probe shaft, not the pin its self....I found the probe where you can slightly see the beveled end work best for me..... its a choice you have to make.... Now, as far as slug seating depth... again take out your slug barrel and place a slug into the breach.... take the pin probe and place into the breach and adjust the pin for seating depth with the beveled end slightly seen.... or where ever you choose to set the main shaft of probe.....This is all adjusted with the cocking lever rod as you will have to dissemble the gun to get it to the correct depth in chamber.... Also, remember you have to have clearance for the clip to be used......

[@chrisfigueroa3361]

I need to figure out where to get the that firefly 8es90 scope adapter ive had a fire fly camera for over a yr and still have not used it on my scope i tried the Orion adapter on the side shot but that didn't work so maybe you van help awesome videos you make thanks for sharing be safe buddy

[@ravenshield7823]

You should care more about where the skirt winds up than the probe itself. Some pellets have a deep skirt. Not sure what caliber you have but something to consider. Obviously, slugs are different. You have plenty of air flow either way, you actually will need more air for the same velocity because you are increasing the cavity displacement. Things to think about.

[@numizaairguns1373]

I just use medium and heavy slugs, buddy!

[@papaoskie]

Also check how your pellet or slug seat in the liner

[@rockyourfaceoff2]

Curious to know what everyone sets their pellet seating depth into the rifling and why. Trying to understand it

[@ravenshield7823]

You want the skirt to pass the transfer port, adjust it according to your ammo. Otherwise, the blast of air can bend the skirt.

[@numizaairguns1373]

improve better seal to push heavy bit fast