This Is What To Many BURNOUTS Does To A Volkswagen VR6 Engine! Engine Teardown

We knew the engine was knocking, But I never thought it would be this bad. Thankfully the engine block survived. We will be replacing all bearings, a crank, and pistons and rods. Im going to do it the cheapest way possible. Watch and see what we end up doing! Will it ever run again?

[@adrianw3985]

There is no such thing as "Too many burnouts"

[@krismont]

smal advise - just swap the engine, leave this one for parts because cleaning this one will be very difficult plus heat spots could damage block so U should legalize the main bearings (check if they are in line); overall : it's not worth it, especially that U are using it hard.... regards from Poland 😶‍🌫

[@KBMOTORSchannel]

Thank you for the advice! My family is from Poland. I have already purchased a new crank rods and pistons. I am torquing in the crank today. I sure hope I hope works out.

[@krismont]

well, I wish U the best, I also hope that it will work, if not the second one is waiting right there... 😅 @@KBMOTORSchannel