This will be needed in every workshop. Woodworking. DIY.

[@kiavooshdevansallare8145]

تمام مدت منتظر یک ابتکار جدید بودم ولی نشد که بشه !!!

[@Sdjhabuakadesi]

Super banaya bhay

[@jimrosson6702]

Great job

[@easymake414]

Thank you so much for watching.

[@cruzruiz3778]

Hola EASY MAKE , muy buen proyecto felicidades y gracias por tú valioso tiempo.

[@bdanc]

Keren hasilnya 🎉

[@richardefriend]

Just a DIY planer that's not all that sturdy, and with a more complex build out than was needed (use strips instead of cutting out the middle).

[@audid00dy]

One question why did you have to drill twice before fixing with screws, the first was a countersink but then you used a second drill bit?

[@jamescomerford8358]

screws were longer than the countersink might not be absolutely necessary but not a bad habit in the edge grain of plywood

[@migunismigunis]

Годно!👍👏

[@easymake414]

Дякую за перегляд.

[@migunismigunis]

@@easymake414 дякую за вiдio

[@zaebynder1985]

👍💪🤝

[@MrFoxRobert]

👋👍

[@kevinohara8671]

Very good but your dust extractor isn't being used enough you may have a mask but the dust will go everywhere in your workshop and be moved about all over just an observation I suffer with a bad chest so it is so noticeable

[@johnbrown6189]

Safety tip. Never let go of a spinning router.

[@АндрейМорозов-д4с]

В мастерской имеется рейсмус , а с этой лабудой топорная работа получается.

[@zaneseligman1313]

Ok- I’m not sure what high school this was filmed at- but I have no idea what he made or used the box for. At the 7 minute mark I was ready to install a ballast and wiring

[@richardspencer742]

It's a router sled, with a flattening bit it's used to do just that - flatten pieces of wood. Typically end grain or large slabs to big for a thickness planer

[@GudduBanjara-iq3kj]

Llllllll

[@GudduBanjara-iq3kj]

L

[@GudduBanjara-iq3kj]

L

[@GudduBanjara-iq3kj]

L

[@gul_68gar5hk]

Мне не понадобится!

[@Tensquaremetreworkshop]

It won't be needed in my workshop. If I need to thickness an area I would use my CNC router.

[@romankuznesov1921]

Без того пристрою,що циклює наврятче!

[@blainedrayer4776]

Waste of materials and time rails too high and need better guides on bottom. Poor technique used.

[@grampareyem]

Please title your videos!

[@williamwheeler1658]

+

[@hagengocht3891]

What a complete joke and a waste of time and lumber…