As an fyi for the comment readers: It is possible to do this with the throttle body left in the car, perhaps not optimal, but possible. Disassemble the intake as you see here to access the throttle body. Then depress the accelerator pedal to open the butterfly valve and reach in with a small brush to clean the throttle walls and valve. Be aware the you will have turn on the car (not start.. just on) to move the throttle valve to the open position. If the MAF sensor is unplugged when you do that then there will be two codes that you'll have to clear after you put everything back together. Avoid the codes by plugging the sensor in when the car is on - or just clear them if you have and obdii scanner that does that. Also note that Honda's service manual state to avoid getting cleaner in the throttle valve bearing area because there is lubrication in there that can be washed away.
@PEN1_Ontario_9097 жыл бұрын
Jim Trainor yup I had my wife put the pedal down to open the butterfly sprayed on a rag and cleaned the throttle body... put it all back together started the car and got a MAF sensor code... rest the code idle and everything runs smooth
@billn9n3 жыл бұрын
I did this and the Idle is not jumping after I let go of the gas. Any idea? I didn't take it off just cleaned with the value open as u said.
@jptrainor3 жыл бұрын
@@billn9n Give the car time to relearn the idle. Honda says idle relearn takes five minutes after the car is warmed up to operating temperature. Leave lights, ac, and fans off (anything that loads the engine at idle) while it relearns. If that does not do it then I don't know.
@billn9n3 жыл бұрын
@@jptrainor OK I will try again. Should I do the relearn as shown in videos with holding the rpms to 3k for 3 mins and what not?
@jptrainor3 жыл бұрын
@@billn9n The 3k rpm for 3 minutes is to warm up the car. I don't think it's really critical that it be exactly that as long as the car is warmed up before you leave it to idle. But the car does have to be warmed up to operating temp to relearn the idle. Honda's normal cold idle is around 1500 rpm when you first start the engine. It drops down to 650 or 750 rpm as it warms up. The exact warm idle speed depends on the engine and your location. Colder climates have a higher warm idle.
@Shachar857 жыл бұрын
Great Video! I did it yesterday and the video was a huge help. thanks
@UCARby7 жыл бұрын
Thanks. Glad that it helped you
@jmadelacruz3 жыл бұрын
Can we do idle learn without the honda diagnostic system app? thank you!
@StandFastable4 жыл бұрын
Are you fking kidding me it's so much easier on plenty of other cars 😩
@guyelsenburg91962 жыл бұрын
Yeh i think its a shop job for me lol
@mr.superstar79192 жыл бұрын
You can do it yourself without removing the whole throttle body
@rTravtrj4 жыл бұрын
I've always heard you should never spray the cleaner directly into the TB and only onto the towel. I have a 9th gen so if it's different for the 8's please let me know
@szilvipeter78762 жыл бұрын
How do you connect the laptop to the car?
@shamanjitsingh72672 жыл бұрын
Please share the software and equipment used for idle learn procedure.
@tshephomaringa5824 Жыл бұрын
Please share the software and equipment used please
@guillermomarin9757 жыл бұрын
Hi your video was helpful where did you get the honda program is there a way to get it will it work with any computer on any os?
@nipsey32215 жыл бұрын
Replaced Pcm Now It’s Saying I Need Idle Relearn Will This Help ?!
@Trojak914 жыл бұрын
Hi can you tell me what interface hds you using I'm trying to buy something to my civic 2009
@marktoth82352 жыл бұрын
Can you do this with other programs? Can you connect lets say a delphi obd2 with this program?
@PericoDeLosPalotes-z7i15 сағат бұрын
Thank you!.
@user-qc7hr4my7r4 жыл бұрын
Will cleaning throttle body fix a tps sensor code?
@Gary_Fergusons_Lover3 жыл бұрын
It can. Just clean the rim of the plate and where it sits in the housing.
@kainhall2 жыл бұрын
No
@nikoslagis8 жыл бұрын
Very good video ! Where can we find the Honda Diagnostic System and obd2 interface , i guess honda is not selling them on retail .
@UCARby8 жыл бұрын
Thanks! Sorry for the late reply. I've used chinese copy of this device, which I ordered here: www.aliexpress.com/item/2014-Newest-Version-V3-012-023-for-Honda-HDS-HIM-Diagnostic-Tool-with-Double-Board-HDS/1838749350.html
@nikoslagis8 жыл бұрын
RoadRiveR thank you very much! Going to order one !
@nobilitas167 жыл бұрын
+RoadRiveR does that software have access to vtec, fuel injection, etc?
@mkrp46 жыл бұрын
My crazy neighbor ordered this software to change a key code on my car 2007 Fit (so I would not able to start it). However his software was fake and counterfeit (made in his native country) and it did not work. As he was trying to figure out why, the cops arrived. They confiscated his laptop and master keys. (He was not arrested because of mental illness)
@zayneali31484 жыл бұрын
@@mkrp4 hahha nooo way. Seriously? This is hilarious
@sumdooky4 жыл бұрын
Do what now?
@rodniejorge19222 жыл бұрын
Greetings, question: Does the throttle body of the 2007 honda civic have the IAC valve integrated?
@fzghbkhvgfhhgv35242 жыл бұрын
Did u ever get your question answer , I’m thinking about cleaning the IAC on my 2006 civic also and don’t know if it has it
@kainhall2 жыл бұрын
Electric throttle body's usually just crack the butterfly open for idle air control . But I'm doing this job... I'll reply back in an hour or 2 to let ya know . If I don't reply.... their is NO iac valve
@fzghbkhvgfhhgv35242 жыл бұрын
@@kainhall Thks bud
@kainhall2 жыл бұрын
@@fzghbkhvgfhhgv3524 no IAC.... just the EVAP purge valve and butterfly . Helped a TON on this car . Also, I didn't need to remove any of the wiper panel stuff.... but I work on cars for a living (so small spaces aren't a big deal)
@kainhall2 жыл бұрын
@@fzghbkhvgfhhgv3524 also... I'm 6 foot 5 So to save my back.... I just got on my knees . WAY more comfortable Just don't let your shop buds see ya . Might get some "ya practicing??" Comments LOL
@thomasmanges38917 жыл бұрын
The air cleaner housing has a bolt in the top left, it doesn't appear to be for a socket of any kind. Does it just pop out? Or how did you remove this?
@PEN1_Ontario_9097 жыл бұрын
Thomas Manges it's a damn rivet with a rubber seal I pulled mine off but couldn't get that rubber seal back through when I put it back on... i said fuck it pushed it down and put the other 2 bolts on
@kainhall2 жыл бұрын
@@PEN1_Ontario_909 use a little white lithium grease or oil on it . Pops right on
@unknwnoutcast43882 жыл бұрын
Is this process need it also for a 2006 4 door?
@shivaan30002 жыл бұрын
Yes
@markbautista76605 жыл бұрын
Does the relearn procedure apply to a 2007 crv?
@E_P14 жыл бұрын
английский русскоговорящего годаздо понятнее)
@LuisRodriguez-bn8be3 жыл бұрын
I have done this with a scanner tool and my idle goes around 750. But whenever I turn off the engine, and turn it back on it comes back to around 900. I do the reset with a scanner and the relearn just like you show on this video, but never seems to work after I turn off the engine.
@tommyboubou2 жыл бұрын
it’s normal it’s post start idle
@kainhall2 жыл бұрын
After you start...it will "high idle" for a few mins . It's warming up the cat and o2 sensors . After a few mins / After temp warms up It will drop back down
@Trojak914 жыл бұрын
Hi I do throttle reset without cleaning but hds shows all time time idling relearn is complete.. do I need to reconnect and clean throttle first ?? Another question is what is a standard idling rpms ? On hot engine ? I have something like 650-679 rpms and my car shakes a bit on idling. Thanks for your answer;)
@thephoenixcycle88542 жыл бұрын
I think this is probably what my Honda needs because when the air conditioning is on at idle, like at a stoplight for instance, the car shutters the revs drop momentarily in the car feels like it's going to die. It hasn't actually died yet but it's very disconcerting. After watching this video. This is not for the home mechanic. At least not this home mechanic
@AudreysKitchen Жыл бұрын
Hello. I was wondering if you had work done or got this figured out. Thanks
@Dada-gk9ic Жыл бұрын
Did you manage to solve your issue??
@kevinward74983 жыл бұрын
Holy shit, all that just to clean a little gunk off the throttle body and valve? I miss my CRX! Computers weren't made to simplify our lives, but to complicate them apparently.
@idrisb072 жыл бұрын
The lack of room under the hood of this car is ridiculous
@UCARby2 жыл бұрын
Totally agree
@jaustin84214 жыл бұрын
Or use cleaner spray and no need to remove half this stuff!
@prestondarnell954 жыл бұрын
What's the link to the website
@cloud-ny5ux2 жыл бұрын
could you feel any boost in performance?
@UCARby2 жыл бұрын
Probably I felt just a slightly faster response of the engine when pressing the accelerator pedal. But now I think it was just a placebo effect))
@kainhall2 жыл бұрын
It's not gonna make more HP . Just idle smoother
@dd___dc4 жыл бұрын
Y do u have to do a relearn idle positions
@kainhall2 жыл бұрын
Because if you dont...it will idle too high or too low
@ROMA2MECANICA7 жыл бұрын
How much is that computer
@AndreiGog6 жыл бұрын
And they say BMWs are complicated haha
@ivands72494 жыл бұрын
Who says bmw are complicated? They're pieces of shit, not complicated at all 🤣🤣🤣 lil honda would outlast that pos still...
@aykutoz56606 жыл бұрын
İ am clean like for u thx !! Hds best !!
@adamsokoowski23196 жыл бұрын
Speak english ?? Ok... Then choose english language in honda diagnostic program!!. I and many others dont how to read russian letter!! Delete this movie and upload in english
@kainhall2 жыл бұрын
He is speaking English . He also translated every button he pressed to English . If you can't follow this.... sell your tools You are doing more harm than good to your car