Throttle stop screw removal on ct200u-ex! 9 Mph gain! Coleman Budget mini bike part 3!

Today I am going to be modifying the throttle stop screw on a Coleman ct200u-ex
#minibike
#throttlestop

[@Deucealive75]

Trimming down the spring is something that more people should know about. I did that to my Colemans years ago and it works great. If you trim it too far you can add the small spring that GX200 and clones come with including Predator. The small spring helps get it back to idle.

[@UTKhaliq]

Nice. Much easier than all the other mods out there.

[@connerdavis2450]

Definitely one of the first mods everyone should do!

[@philliprodriguez3048]

Still works fine

[@connerdavis2450]

Good to hear!

[@bashingrc3686]

I’m worried about the valves floating will this happen

[@connerdavis2450]

Yes you are correct in my stage one video i dropped a valve. So I recommend 18lb springs and a tach and keep it around 5500 for cruising and no more than 6000 preferably cause I drop my valves at 6400 lol stage 1 makes a really big difference!

[@kylercontreras6044]

was your governor removed when your valve floated ​@@connerdavis2450

[@connerdavis2450]

Yeah basically just zip tied it wasn’t removed until a later date. Thanks for watching

[@kylercontreras6044]

@@connerdavis2450 yeah of course, one more question though. do you know if it's safe to remove the throttle screw if you have the governor still installed and not modded at all

[@connerdavis2450]

@@kylercontreras6044uh it’s been so long since I did the throttle stop. I would recommend just installing a tachometer and keeping an eye on the rpm.