Eagerly awaiting... I have to implement a rather complicated, multi zone conveyor safety solution to my project. What started as a simple status HMI for monitoring status of all the equipment on a food production line, has expanded to a Line Configuration control center for changeovers and certain reset functions. Your videos really helped me not to bounce off the rails, as this is my first use of the Micro 800's. All of the machines are less than 3 years old and use CompactLogic L3x processors and PF525 drives. I'm able to extract any information I need from any machine on the line, via Ethernet. What has been accomplished so far has greatly simplified setup and troubleshooting of this pack line... (and I'm able to accommodate most additional design requests from our production office); all using a single Micro820 and PV800. Thanks for great help in getting me prepared for it! These little controllers are great for line integration.
@TimWilborne3 жыл бұрын
Sounds like you have had some great success Tim. Keep it up!
@akilal-naema1263 жыл бұрын
Hi Tim, we have a cleaning sequence in our machine during this seqeuence everything stand still. It would be much easier for our costumers to be able to open all doors and spray water inside the machine to remove the ice but the safety doesn't allow us to open the doors. Is there a way to bypass the safety during that cleaning seqeuence? If there is a way, is it in the PLC program or in the guardmaster logic? ( we have three door sensors)
@TimWilborne3 жыл бұрын
Bypassing safeties is always a no no. The cleaning sequence needs to be designed into the safety system
@svojasakdant21803 жыл бұрын
Hello Tim, I am svojas Need to know about gaurd-masters programming software
@TimWilborne3 жыл бұрын
Hi Svojas. We might hit that a little later depending on how this CR30 series goes.