Toyota Dash Lamp Bulb Replacement

[@katemaglalang5757]

Thanks for posting this video! I found a quicker/easier way to replace these little bulbs at least for my 2010 Corolla. I started off my removing the ashtray, then the part where it has the aux and clock, and then removing the entire dash lamp/controls itself. I then followed your steps of how to remove it individually, BUT I found out that detaching the 2nd white part of the control is unnecessary. Just flip the control upside down and use a small flathead to unscrew the bulb and then insert your new bulb and use the flathead to screw in the bulb until it’s tight. And this applies to the other 2 controls, remove it individually and just flip it upside down to unscrew the bulb with a small flathead. This saves SO much time. I ordered the 3 new light bulbs from a Toyota Dealership & the total was less than $16. It looks great!! Yay.

[@chinep8540]

Mmmmmmmnnmmmmnnnmnmnnn;;;n;N ;;

[@chinep8540]

;nn;n

[@jenninenordle5485]

100 % easier. I had to replace the middle dial and the bulbs were all blown. This was much easier for me to just flip the whole part over and replace. Thank you!

[@josephv1882]

Kate maglalang mine bulb just went out 2012 Corolla can you do a video of the quicker/easer way that you just mentioned

[@gonzalotapia1250]

1:17 Save yourself all the hazzle. Remove just the cables. Once you got the entire assembly out, turn it over and grab a flat screwdriver. There is a white part where you can put a screwdriver and unscrew, exactly in the middle of the back of the knobs (you can see it, when you replace the bulb, at 3:47). Replace the bulbs, connect all the cables, replace assembly

[@michaelamac956]

My light has been out for years and I finally have a chance to fix it, thank you for this video, very much needed!

[@armandoramos1949]

Thanks to people like you who are not afraid to mess up. Thank you for sharing.

[@MrCalmann]

Nicely done. Concise, clear instructions and right to the point on how to do it start to finish.

[@travisfrost5175]

Good video. I wanted to change a bulb. It looks like a involved process. I might leave it

[@meinders7810]

I like how direct you were with the instructions without a lot of other fluff!! Thanks!

[@SevenFortyOne]

Glad you found this helpful!

[@marxseet]

This is a T4 bulb, I changed it to the LED one which is brighter. But I don't dismantle the whole front part of the knot to change it. I approach from the back where there is a opening. Just use a thin long legs plier to grab the back of the bulb, turn and pull. Much easier

[@sk8erben176]

Do you have a link where you bought the led bulbs?

[@HeathJ.Ledger]

Very detailed video. Great job man. Better than some other knuckle heads out here that can’t explain for their dear life! Thanks for this!

[@mattcraztex9940]

Thank you for the very detailed video on this I have a 2010 RAV4 and this also worked for me as the dials and wiring is exactly the same.

[@mdd47]

I have bulbs burned out on my 2013 and I tried to fix it, nothing but frustration. I bought the wrong bulbs, so that didn't help anything, and in the process of disassembling the center knob I broke it so now it doesn't have stops at each number. I can't believe they made this thing so damn complicated to fix a simple little light bulb.

[@SevenFortyOne]

I don't think the bulbs are expected to fail. Having said that I wonder why they didn't use LEDs

[@mdd47]

@@SevenFortyOne I just bought a whole climate control assembly (all 3 knobs and the faceplate) from an Ebay parts store. It didn't cost me that much more than it would have to buy 3 new bulbs, and it will be a whole lot easier just replacing the whole assembly. Great video though, I'll definitely pull it up again when I need to separate the front end from those rear pieces on the old one then re-install the new one.

[@SevenFortyOne]

Ok good luck!

[@chillyr1998]

This video helped me fix my 2009 Toyota Corolla. Thank you!

[@Radiowild]

Never knew they could go bad, but now I do..... Thanks for sharing!

[@SevenFortyOne]

Me either!

[@larrycheverie]

Thanks is there a bulb under all three buttons

[@octoberboiy]

How do you change the light for the outer switch? There’s a different bulb that illuminates that part of switch. The bulb you used only illuminates the middle button.

[@mirnarodriguez8987]

I need to know how to replace the dash board lights toyota corolla iM 2017

[@blisterbrain]

I like the bit where he says< "I'll just work it off with this tool" and the trim piece shoots off into the air. Not much working being done, there!

[@redtobertshateshandles]

Thanks dude. I'm assuming the Yaris uses the same globes. Maybe not but that always happens. SOBs can't just use normal globes,can they.

[@SevenFortyOne]

The Yaris is really a Mazda believe it or not so it might be different

[@redtobertshateshandles]

@@SevenFortyOne mine is an old '06 YRX. Internet says 2019 are Mazda's???

[@SevenFortyOne]

@@redtobertshateshandles I stand corrected...I guess just the newer ones are Mazdas like you said. I misunderstood what my buddy told me.

[@redtobertshateshandles]

@@SevenFortyOne no sweat. Like my stubborn Danish mate says. I thought I was wrong once, but I was wrong.

[@yawmxaivchannel]

Very detail oriented and helpful video. good job. keep posting more videos brother.

[@theo66nix1]

where can i get the bulbs ?? I went to every auto part store and they don't have these

[@dest151]

do all three of the knobs light up ??? i only ask because im using one of these cars at night for work and i feel like all three should light up.

[@SevenFortyOne]

All 3 should light up

[@dest151]

@@SevenFortyOne thank you

[@ralcng]

Is it relates to dashboard light? My dash light is not working.

[@kevinbaez8442]

The size is 3mm or 5mm?

[@o10productions46]

Would those bulbs work with the ones in the guage cluster?

[@jimmcmullan1494]

Have you ever changed the gearshift bulb on a Toyota Auris? I'm just not sure whether the flat surface pops straight up & out, or you have to pop out the side trims first?? I just don't wanna damage any of my trim. Any help would be greatly appreciated. Thanks Jim

[@SevenFortyOne]

Sorry, I haven't

[@huskyng6981]

hi the ebay or Amazon part number is not working, do you still have the part number for the replacement light bulb please...

[@michaelhultman9976]

Same

[@nivehnumaharan2668]

Does the Sylvania Long Life 74LL Mini Bulb do the job as well whne fixing the light?

[@SevenFortyOne]

I think it will

[@ashrafalattar]

@@SevenFortyOne The Sylvania Long Life 74LL Mini Bulb does not have the plastic base. Any suggestions how you can use the Sylvania bulb? Thanks.

[@damer950]

For auris 2008 fits T4.2 led bulbs..

[@joshclark3294]

I lost the little plastic gear knob that turn inside the knob. You where I can get one.

[@victorcastellanos1081]

Thanks for your video couldn't of done it with your guidance

[@YYZ297]

Just wondering if Sylvania Long Life Mini Bulbs 2721 can be used?

[@SevenFortyOne]

Maybe....just have to sawp them into the holder and try I suppose

[@YYZ297]

Thanks for the quick reply. Will try and see if it works.

[@sk8erben176]

@@YYZ297did it work?

[@YYZ297]

@@sk8erben176 No it didn’t work. I purchased OE part from Toyota.

[@dfwreyesfamily]

I didn't see a link to the bulb in the description and it's not in your store either, do you have the part #?

[@SevenFortyOne]

It's not available on Amazon any more so the link disappeared. I don't have a part number but if you read the comments someone posted a part number to a bulb that should work but you'll need to reuse your socket

[@dfwreyesfamily]

@@SevenFortyOne thanks

[@nivehnumaharan2668]

What do I do if my gears don’t turn when I instal it, what should I do next?

[@Abusofwaan]

Could someone please assist with the part number. Could it be a T4 12V?

[@MRxSENSEIxAZN]

I have a 2012 corolla s and bought the bulb in the link but it’s not the right one 🤦🏽‍♂️

[@JonathanAbbott]

The dial knob got out of position and so it took about 5 tries to get it right. Overall 1.5 hrs. Both the back ring gear side and the dial knob have hard stops, which you'd find if you can't get full travel. So do yourself a favor a rotate everything one way to begin. The snap fits were poorly located and toleranced and the assembly was not designed for ease, so expect a lot more hassle than is shown.

[@coelho52872]

For anyone about to do this project, to avoid this issue, just hit the 3 pieces with a sharpie line through all 3, so you can make sure all the piece are lined up correctly for reassembly.

[@buzzsah]

A good save, the dealer just lost big. lol

[@SevenFortyOne]

You bet! How are you feeling? Looks like you are keeping active which is good to see!

[@buzzsah]

@@SevenFortyOne sO FAR SO GOOD, FEELING BETTER EVERYDAY. Oops lol, I just bought the Alinco DR 638 , seeing its fcc part 90 I can use it on the Auxnet but first I need to mod, however I can't find the tx mod so far. I meant with the CT radio coordinator today and he wants me to take over his position. hmm!!! Right now my first priority is the tx mod for the 638

[@SevenFortyOne]

@@buzzsah Glad to hear you are feeling better! Good rig - it should work well for you. And you'll make a great coordinator!

[@buzzsah]

@@SevenFortyOne lol, thanks, I need to think about it, I have a lot on my plate with Capt of Fire Police, Safety training instructor, USCGA, Navigation instructor, ....... You know how it is. If you see the tx mod for the 638 let me know, so far no luck, there is 1 vid on YT where he said cut the blue wire jumper and thats it, well there isn't a blue wire jumper, there's no wire jumpers. :(

[@saeedsaleh6784]

Hello.. This corolla s class??

[@SevenFortyOne]

Yes

[@glll7501]

Anybody know the bulbs for 2011toyota

[@gonzalotapia1250]

90010-01122 is the exact part number. It is a Neo Wedge bulb, but I'm not sure if it is a T4 or T4.2 size.

[@kc9jts]

Very helpful, thanks!

[@marksraab900]

what is the actual size of the bulb? I have a 2007 camry and need to replace two of the three climate control bulbs

[@SevenFortyOne]

Sylvania Long Life Mini Bulbs 2721 may work...The ones I bought on Amazon are no longer available.

[@Albert-rg5qi]

it would be better to disassemble to get the old bulbs first and look for them in a autoshop.

[@taylorgoldstone-perez34]

Appreciate your help.

[@siktunez8910]

i jus changed the shift gear light and im going to do this next..i have to do it cuz i paid a place to do it for me before...and now the lights went out again. i definitly got robbed since this is so easy

[@sharomkaiser5116]

I just found out the bulbs you put it in your description that’s not the correct on because you need the bottom cap with this one too ... one you put it on the description that just the bulb not the bottom part I would recommend buy it from the dealer will be best option I order from amazon the link you provided that bulb fits but need it the bottom part to hold it ... tomorrow I am going to buy it from dealer tomorrow .... actual current part number for this pacific is Part Number: 9001001122 Supersession(s): 90010-01122 AIR CONDITIONER CONTROL; HEATER CONTROL. Fits Corolla (2009 - 2013)

[@ainsworthainsley7914]

Thanks much!

[@hunterdouglas9765]

Video is 7 minutes, 41 seconds long. Nice.

[@SevenFortyOne]

That was purely coincidence which makes it even cooler

[@RegimeChangeEritrea]

Good job

[@alexanderbleichner5888]

PSA: His new bulb recommendation does not work for 2009 Corolla

[@rushattack1]

Thank you nice video

[@DwightMclean-c8z]

That’s not the one it’s middle one

[@1988jpcesar]

Car came apart like a lego

[@blasi1800]

This way too much work for a stupid bulb!