Toyota Prado intake - 120 bonnet scoop installation - Air Intake Intercooler Scoop

[@RUPIX75]

Been looking for a video on this! Thanks mate, great video! Can't wait to get mine done

[@michaeltsimouris5304]

Great video thank you, I fitted the 3 scoop unit off an 06 Hilux and it was a lot simpler, no issues with having to cut out the front screw.

[@GOWITHELDON]

Any potential issues with water entry thru the scoop?

[@jasonyannuccelli2499]

That was a very informative and helpful video..Thank you.. It looks great but so from a looks perspective well worth it but do notice any improvement in power or economy or any other ? I am wondering if by removing the intercooler and fitting it up at the front behind the grill would give any noticeable benefit or if it would disturb too much of the air flow to the radiator ?

[@philosophactory]

Do you think you could have modified/cut the plastic rather than notching out the metal bonnet??

[@terryyouth]

good work . what if you had used a 3m tape too ?

[@stanmuwowo1719]

Safety first. Eye protection while using cutter

[@colinmonaco2128]

Good job

[@ryanlee5432]

Any negative effects, in particular water crossings?

[@wil3080]

Hey mate did you make a video how to install the boost controller?

[@orlando1986100]

Very Nice

[@deely6175]

Can you do my prado?

[@Kranky_Frankie]

I would mask more of the bonnet if using a angle grinder to avoid marking the paintwork where the sparks land !!