The correct tool really helps in removing these sensors! Great video as usual Jim!
@jimthecarguy3 жыл бұрын
Thanks 👍
@michaelmann-worley2753 жыл бұрын
@@jimthecarguy hey Jim I just changed the brakes on my wife’s 2015 highlander. We also had to replace the front left caliper when bled the system but she says the brake pedal goes almost to the floor before the car stops. Do you have any idea what’s causing that or know what we did wrong when bleeding the system? Does the car have to be running to bleed this certain type of vehicle
@andrewmcmillions31383 ай бұрын
@@michaelmann-worley275did you ever find out what this was? I changed my brakes on a Toyota Tundra like I always have successfully and my pedal was pushing down to the floor with little braking. It ended up being my brake booster and master cylinder needing replaced and it was just coincidence it happened at the same time
@abdomokhtar36392 жыл бұрын
Thank you very much for this program
@williammchaney17922 жыл бұрын
Great video! But I don't think you mentioned the size of the socket. Thanks Jim
@steffaniemamawithapurpose73242 жыл бұрын
right we know its a maco but...size plz
@chimmpoe2 Жыл бұрын
21 MM
@yeye3195Ай бұрын
7/8
@BigDog500013 жыл бұрын
Thumbs up Jim!
@ahmadghosheh31043 жыл бұрын
Yeah, I have taken cars to the shop to install a part I couldn't install and didn't want them to do anything else. Last one was my brothers 2005 Honda Civic. I was replacing the PCV valve, done many of those before, bit this new oart will not screw in, took it in for them to do it, spendy but they got it in, it was way in the back and at an angle. Weird.
@williamhubbard41722 жыл бұрын
Thank you!
@jimthecarguy2 жыл бұрын
You're welcome!
@robertwilliams79693 жыл бұрын
Good advice
@MAAC3GEEh2 жыл бұрын
jim is this upstream or downstream
@MrTruckerf2 жыл бұрын
In front of the cat con would be upstream.
@gracioustea53193 жыл бұрын
Was that sensor 1 bank 1?
@leonardoroblez5833 жыл бұрын
Grasias maestro.👍🏻
@rondoschiavoni88403 жыл бұрын
SAY Jim HOW DID YU GET THE CONNECTOR TO FIT TH EPLUG IN THE VIDEO IT WOULDNT CLICK IN ON TOP OF TH EENGINE ,THEN YOU WENT TO THE BOTTOM AND PUT THE NEW SENSOR IN ,NOT EXSPLAINING AVBOUT THE CONNECT NOT FITTING IN ON TOP