Transfer Pump w/Honda GX 200 Engine: Only Runs When Choke is on Full

  Рет қаралды 7,038

L&M Small Engine Repair

L&M Small Engine Repair

Күн бұрын

Пікірлер: 15
@mongrel1799
@mongrel1799 Жыл бұрын
good pace on the video, easy to follow. I'm in the same camp, only running with choke partially engaged. Pulled the carb and cleaned things up, but the main jet is "welded" in and won't come loose. I ran a copper wire strand up there and it looks like decent flow... I'll button it up tomorrow and see what's what. Thanks!
@mikebuckley5740
@mikebuckley5740 6 ай бұрын
The spring is to keep the throttle rod tight
@jonlambshead5115
@jonlambshead5115 Жыл бұрын
I Hate Those Stupid Plastic Idle Screws , They Cross Thread If Your Not Careful & They Break Off As Well. Other Then That , I Love Honda Motors. So Easy To Rebuild, Parts Are Cheap & They Last For Ever, If You Look After Them Properly With Oil Changes ETC
@Newfiestang50
@Newfiestang50 Жыл бұрын
surface of engine between carb and engine looked pretty dirty. And not sure but didnt see a gasket there. surprised you never inspected that.
@lmsmallenginerepair4471
@lmsmallenginerepair4471 Жыл бұрын
there was a gasket
@carlodonnell146
@carlodonnell146 Жыл бұрын
If the fill hole is opened too, it may drain faster. I wish the gas-tank had a drain plug. Are you suppose to drain the tank through the carburettor?
@lmsmallenginerepair4471
@lmsmallenginerepair4471 Жыл бұрын
yes or just take off the fuel line
@laurianopaniagua3825
@laurianopaniagua3825 11 ай бұрын
I have a Honda gx160 when i start it, it starts good when i go to move the choke back down it accelerates to the max, instead of it staying stable. Can you give me an idea what it could be. Thanks
@lmsmallenginerepair4471
@lmsmallenginerepair4471 11 ай бұрын
is the throdle stuck on the carb
@carlodonnell146
@carlodonnell146 Жыл бұрын
Hi L and M, A question for ya! Why would a new exhaust muffler on the gx200 cause back fires and rough running. I replaced the exhaust on my gx200 honda and it back fired badly and loud/rough. I ended up putting back on the old one. The new muffler is a little smaller than the old one, would that cause it?
@lmsmallenginerepair4471
@lmsmallenginerepair4471 Жыл бұрын
yes
@JesseGreer-f2y
@JesseGreer-f2y 9 ай бұрын
You'll have to rejet it.
@sootie620
@sootie620 6 ай бұрын
Your a bit like myself in the hands department, whitewash brushes, not easy for the small components 😜😎
@lmsmallenginerepair4471
@lmsmallenginerepair4471 6 ай бұрын
Very true!
How to Clean a Honda GX Carburetor
17:15
Eliminator Performance
Рет қаралды 257 М.
Правильный подход к детям
00:18
Beatrise
Рет қаралды 10 МЛН
Quando eu quero Sushi (sem desperdiçar) 🍣
00:26
Los Wagners
Рет қаралды 14 МЛН
The Best Band 😅 #toshleh #viralshort
00:11
Toshleh
Рет қаралды 21 МЛН
How the Small Engine Governor Works
5:09
Kohler Engines University
Рет қаралды 1 МЛН
Honda GX160 Carburetor Service (Same for GX120, GX200, GX270, GX340 & GX390)
13:11
Melbourne Power Equipment
Рет қаралды 40 М.
Carburetor Replacement GX160 GX200 Honda
12:48
RedneckComputerGeek
Рет қаралды 45 М.
HONDA GX160 ONLY RUNS WITH THE CHOKE ON DIES AND SURGES
10:44
DIY MACGYVER GUY
Рет қаралды 79 М.
Honda GX160 Only Runs on Low RPM
8:11
Eliminator Performance
Рет қаралды 23 М.
[4 Quick DIY Fixes] Generator only Runs on Choke / Half-choke!
11:35
Home Battery Bank
Рет қаралды 187 М.
DEWALT/HONDA GX200 PRESSURE WASHER WONT START | FIXED
18:00
Freedom mowers
Рет қаралды 6 М.
Honda GX120 Troubleshooting Won't Start Issue
9:57
BSK Garage
Рет қаралды 397 М.
Honda GX160 - Shutting Down after Getting Hot
12:04
Eliminator Performance
Рет қаралды 129 М.
Honda Clone (GX390) Engine Rebuild - Low Hour Engine Dropped a Valve
1:29:21
Правильный подход к детям
00:18
Beatrise
Рет қаралды 10 МЛН