TRAXXAS SETUP -- USING THE EZ START SYSTEM (HD) 9 OF 21

[@cody1995evo]

Man, these videos bring back memories

[@nighthawkj30A4]

2004 was such a good year

[@Jasonkartracing]

I use a 2s lipo in my easy start the lipo I’m using has the xt60 plug. With just a little wiggle it will plug in just make sure the positive and negative are in the right spot. It was a hard case lipo and I removed the case for more room. It starts the engine a lot faster and it’s a 5000mah so you don’t have to charge it as much. I also use a 2s lipo on my glow igniter on my pull start. I got a cheap glow igniter that had alligator clips and I cut them off and soldered an xt60 plug to it

[@scottshake8440]

can you give me a link of the battery PLZ

[@SesameSTHater38]

what if u hooked up a lipo to it

[@yoyoman2k1]

well that depends on which light is lit one is for the motor and one is for the glow plug ... so if the light for the glow plug is not lit up then you probably need a new glow plug and if the light to the motor isnt lit then there is a problem with the motor. for example could be a bad piston .....it should say on the ez start by the lights which one is for what and go from there ...hope this helps

[@Tyler5.0]

Hey man can u tell me why on my easy start there's only one green light when I try to start it thx

[@arturos.l.2248]

Either your glow plug is unplugged, having a connection issue in wiring, or the glow plug is bad.

[@arturos.l.2248]

When the glow plug goes bad you have to take it out and replace it, drain the fuel out of the tank and engine

[@milkweed728]

dose anyone know the size of the motor and gear box size from mounting screws.please can someone tell me this.

[@christovoe]

when i try to start my s-maxx the glow plug light flashes

[@jcarlofd91]

Can anyone tell me how to plug the glow plug wire pleaseeeeee

[@marioaloisio5040]

Buona sera si può installare su SAVAGE X grazie, e grazie per il video

[@xXBullets78]

Can this work for the CEN GST 7.7?

[@pancakeairsoft7145]

xXBullets78 if it has the same holes for screws where the pull start go it should work

[@paulparks3588]

Yeah we skip the part where if the glow plug light don't come on

[@bigmike547]

Wen I try an start my jato both lights cum on but my motor want can someone help pls