Trex Signature Stair Railing Installation and Tips

[@johnrogers1876]

thank you, I'm going to tackle the stairs tomorrow. put up 3 sections of horizontal rail today. Thank God for youtube and people like you to take the time and explain things

[@rccrashed]

Thanks for taking the time to do this video, there sure isn't much on youtube covering these. The only ones I could find were for the sleeve style going over posts.

[@fkady9664]

I agree, currenltly installing mine .. it's a bit confusing on the brackets location and what screws to use for them. I have four 6 f sections to be installed and finished one section. Today lol

[@michaelmatarazzo698]

Factory directions are terrible. For the cost of Signature rail kits more specific assembly instructions are required.

[@jeffslancik1341]

Nice work brother

[@kerikimmel449]

what is the name and brand of that pencil? The ones I see are permanent

[@Slowdraw44]

@@kerikimmel449 the red pencil was not permanent on the metal. Just wipes off. It’s just a regular colored pencil. I used it for contrast on the back Trex materials. Hope this helps.

[@zaqwer332]

If you cut off all your balusters than your handrail is no longer to code.

[@ivanobar1]

All the vids I’ve seen, the balusters are cut. So either everyone is breaking the code or the balusters run a little long to allow customizing (code specifies hand rail height range 34”-38”).

[@BernardRitchie]

This dude needs about a quart of coffee...

[@Slowdraw44]

@@BernardRitchie sorry I drink tea.