The Triumph workshop manual states that working clearance on the top bush should be between .0035/.0050 thousand of an inch so although l agree the bottom bush should be a good interference fit the top bush was designed to have some play
@441rider8 жыл бұрын
Riding hard I think heat may effect fork bush tolerances. Great vid,
@ncprobst8 жыл бұрын
Very informative. What is the name of the adjustable tool you use to tighten the bottom nut?
@paulnewton64075 ай бұрын
Are you still doing the fork service?
@MrKillerman98910 жыл бұрын
It would has to face downwards because to allow the oil pass through the shuttle vowel.To achieve two-way damping.
@roylewis13097 жыл бұрын
Do you still do this service? I have just obtained a set of 1970 forks for my Bonnie build, but they are SEIZED tight. Any tips or should I send back?
@giamri164510 жыл бұрын
Hi,Mark I noticed that you didn't put the shuttle valve...is it possible without it?Mark my problem is it's knocking when it bounce back....Thanks for your info...
@philipfenton-ree51319 жыл бұрын
Are you still able to make some bushing?
@cliffr60943 жыл бұрын
Hi, are you still offering this as a service, and what is the cost? Many thanks.
@robertllr11 жыл бұрын
Nice info. And maybe you answer a question for me. Does the stepped plastic spacer go on the tube with smaller inner diameter up or down? Does it matter? I notice you glanced at both ends (around 5:18) before putting it on, so obviously you think it does. But why isn't it the same (small) diameter on both ends anyway? All my manuals, shop and aftermarket, are silent on this issue.
@rogerturner23176 жыл бұрын
Jeff Gibson - Hi Jeff. Did you ever see an answer to this ??
@derekcollins19725 жыл бұрын
Taper goes down...I know I'm too late replying.
@allegrobags11 жыл бұрын
you say you offer as a service, where are you located pls? Derek, sutton on sea.
@supdog201011 жыл бұрын
I would be interested in a fork rebuild service if you could offer one?
@navajogal47935 жыл бұрын
I agree I have 3 BSAs needs fork rebuild
@MrSantacruzz3 жыл бұрын
The Triumph workshop manual states that working clearance on the top bush should be between .0035/.0050 thousand of an inch so although l agree the bottom bush should be a good interference fit the top bush was designed to have some play