Tronxy Gemini S Part 4 of 4, First Print timelapse.

[@Golf3gti1]

Hello I bought a Tronxy Gemini S IDEX. And I can hardly print with the print is terrible. What firmware do you have on here ?

[@TheBreadboardca]

i have the stock firmware, what are the issues your having

[@Golf3gti1]

@@TheBreadboardca The print is just awful. Can I send you any way a picture of the print to show you

[@TheBreadboardca]

@@Golf3gti1 [e-mail]

[@johnkaniewski633]

How much are you retracting on your extruder change? My Gemini S oozes badly unless I drop temps, but then at the change the extruder sits over the print as it heats up. I am using an earlier version from before they added the metal wipes, the older one uses brushes, and I am not sure if they have done any additional hardware or firmware updates.

[@scottyboy6269]

I changed to capricorn tubing, but mine are around 1mm 2mm retraction. I have issues with Gaps in layers most likely due to linear advance or bad esteps(which you can't calibrate on these)