Troy built 2620 snowblower start issues.

[@pattayperformance]

Good Morning, Great Video! What diagnostic steps have you taken? The spark plugs for these machines are faulty. I would recommend replacing it with the NGK or Champion equivalent. Also when the spark plug is out...spray some starting fluid down the hole. Install plug and report back. If the machine runs and dies, it’s fuel related issue and you need to take the carb apart and clean again! Thanks for the view and comment, hopefully you subscribed to my channel 🦅🤙🏻🔧🇺🇸

[@sadelcol]

So I check fuel, air, spark, and compression. Its getting all three. I changed the plug and shot starting fluid to see what it does and I got the same results as seen there.

[@pattayperformance]

@@sadelcol what is the compression reading you get vs what they recommend? From what I understand compression can’t be checked due to compression release on the cam. You have to do a leak down test. Next step is to check valve lash and adjust if necessary.

[@sadelcol]

@@pattayperformance yea I couldn't get a good read on comp but would come up 100-115 when I could sent the tester back home with my dad. I was thinking valve lash, or maybe the woodruff key on the flywheel

[@sadelcol]

@@pattayperformance well I found the problem, popped the valve cover and noticed the exhaust valve doesn't move so I would assume its bent.

[@sadelcol]

@@pattayperformance heres what I found kzbin.info/www/bejne/i5_JgaCmq7BlgtU