Рет қаралды 74,862
Watch as compare different 3D printing material agains a 60in foam wing. My goal was to be within 50 grams of the entire RTF foam wing. Using ColorFabb LW-PLA I made a ready to fly LW-PLA wing that was 40 grams over. Challenge complete. I test flew all three of these wings also check it out. Thank you for watching.
Thank you so much for watching!
If you like videos like this, consider buying me a coffee, it really supports me: www.buymeacoff...
See what else I am working on: / troymcmillan_rc
www.tiktok.com...
#3Dprinted,#RCairplane, #ItFlies
ColorFabb LW-PLA: colorfabb.com/...
How to Build Foam Timber: • The Best Beginner DIY ...
Foam Timber Materials:
20x30 3/16" Waterproof Foam Board: amzn.to/3hnmyHn
Motor 2832 Brushless: amzn.to/3gl3bgL
10x4.5 Propeller: amzn.to/2FRyAuX
Prop adapter: amzn.to/2YmXVmT
Esc 30amp: amzn.to/3gl3bgL
6x 9g servos: amzn.to/31kj82B
Receiver ar620: amzn.to/3j4PbK4
Y-Harness: amzn.to/2YrYjAl
Assortment of 3-Pin Extension Cables: amzn.to/3l1xNYt
3S 2200mha Batteries: amzn.to/3l6vCTf
Spektrum DX6 Controller: amzn.to/3l6NFsD
3D Printer: amzn.to/3hn5cdN
Flexible PLA: amzn.to/34mA4rd
You’ll also need: 2x 4.25in Wheels: amzn.to/3ldv5yT
1.5 in tail wheel: amzn.to/3ldv5yT
1mm Push Rod Wire: Purchase this at your local hardware or hobby store, I used solid steel "music" wire 2mm wire for landing gear: Same as above, hardware or hobby store
Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!